Owner’s Manual RoboVac 51005001553 V01
Table of Contents 02 Important Safety Instructions 10 About Your RoboVac What's In the Box RoboVac Anatomy LED Indication 14 Using Your RoboVac Important Tips Before Use Preparation Charge Your RoboVac Use Your RoboVac with the EufyHome App Start / Stop Cleaning Select a Cleaning Mode Use Your RoboVac with Amazon Alexa / the Google Assistant 24 Cleaning and Maintenance Clean the Dust Collector and Filter Clean the Rolling Brush Clean the Side Brushes Replace the Side Brushes Clean the Sensors and Chargi
Important Safety Instructions To reduce the risk of injury or damage, read these safety instructions carefully and keep them at hand when setting up, using, and maintaining this device. WARNING SYMBOLS USED This is the safety alert symbol. This symbol alerts you to potential hazards that could result in property damage and/or serious bodily harm or death.
• Do not handle plug or appliance with wet hands. • Do not use without dust bag and/or filters in place. • Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury. • Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperature above 130°C may cause explosion.
Trademark Notice • Amazon, Echo, Alexa and all related logos are trademarks of Amazon.com, Inc. or its affiliates. • Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc., registered in the U.S. and other countries. • Google Play and the Google Play logo are trademarks of Google Inc. • Google Home is a trademark of Google Inc.
physique doit être utilisée pour empêcher l'accès au balcon et garantir un fonctionnement sécurisé. • Ne rien placer sur le dessus de cet appareil. • Gardez à l'esprit que cet appareil se déplace par ses propres moyens. Faites attention en marchant dans la zone où cet appareil fonctionne, afin d'éviter de marcher dessus. • Ne pas utiliser cet appareil dans des zones avec prises électriques exposées sur le plancher.
About Your RoboVac RoboVac Anatomy What's In the Box A. Top & Side Wi-Fi status light Auto cleaning Start/Stop button Bumper RoboVac Charging Base Remote Control (AAA Battery ×2) Infrared sensor Dust collector Dust collector release button B.
C. Dust Collector Remote Control Filter Return RoboVac to Charging Base 2 1 Adjust suction power level Start Auto cleaning / Stop cleaning 3 4 Control cleaning direction manually Start Auto cleaning D. Suction Inlet 5 6 7 8 Start Edge cleaning Start Spot cleaning Start Quick cleaning Dust collector Install 2 AAA batteries before using the remote control for the first time. Make sure the positive and negative ends are facing the correct polarity direction as marked in the battery compartment.
(Wi-Fi Status Light) f Anti-drop sensors can prevent RoboVac from tumbling down stairs and steep drops in most cases. They may work less effectively if dirty or used on carpeted/ reflective/very dark-colored floors. It is recommended to place physical barriers to block off areas where RoboVac may fall.
Place the Charging Base on a level surface and against a wall. Remove objects within 3 ft/1 m of the left and right side and within 6 ft/2 m of the front of the Charging Base. If you cannot remove the objects, check whether RoboVac can return to the Charging Base normally; if not, contact eufy customer service for help. Method 2: Press on the remote control to return RoboVac to the Charging Base.
You can set the time and customize the cleaning schedules from Sunday to Saturday on the EufyHome app. This function is available in the app only. EufyHome Start / Stop Cleaning EufyHome • Make sure the main power switch on the bottom of RoboVac is turned on before use. • You can also start or stop cleaning via the EufyHome app. 1. Download the EufyHome app from the App Store (iOS devices) or Google Play (Android devices). Press on RoboVac or / on the remote control to start cleaning in Auto Mode.
2. Spot cleaning RoboVac intensively cleans a specific area in a spiral pattern, useful if there is a concentrated area of dust or debris. In Spot mode, RoboVac will stop cleaning after 2 minutes. Press on the remote control to start cleaning in Spot Mode. - RoboVac will return to the Charging Base automatically when the battery level becomes low or when RoboVac finishes cleaning. - By default, RoboVac starts in Auto cleaning mode when it is turned on.
4. Quick cleaning RoboVac will automatically stop cleaning after 30 minutes and return to the Charging Base in this mode. If any small room or area needs to be cleaned, it is recommended to select this mode to save time and power. Press on the remote control to start quick cleaning mode. Use Your RoboVac with Amazon Alexa / the Google Assistant Currently this feature only supports English, German, French, and Spanish. You could check regularly if more languages are supported at https://www.eufylife.
Cleaning and Maintenance Take out the filter. For optimal performance, follow the instructions below to clean and maintain RoboVac regularly. The cleaning/replacement frequency will depend on your usage habits of RoboVac.
Clean the Side Brushes Put the filter back into the dust collector. Foreign substances, such as hair, can easily get tangled in the side brushes, and dirt may adhere to them. Be sure to clean them regularly. Remove the side brushes. Push the dust collector back into the main unit. Carefully unwind and pull off any hair or string that is wrapped between the main unit and the side brushes. Use a cloth dampened with warm water to remove dust from the brushes or to gently reshape them.
Replace the Side Brushes Clean the Swivel Wheel The side brushes may become bent or damaged after being used for a period of time. Follow the instructions below to replace them. Hair or dust particles can easily get entangled in the swivel wheel. Be sure to clean the swivel wheel periodically and as needed. • Pull off the old side brushes and snap the new ones into place. Wheel Axle Pull out the swivel wheel.
Troubleshooting Problems Solutions RoboVac cannot be activated. • Make sure the main power switch is in the ON position. • Make sure the battery is fully charged. • Replace the batteries (2 AAA) in the remote control. • Make sure the remote control is within range (16 ft/5 m) of RoboVac. • If you still have trouble, turn off the main power switch and then turn it back on. The remote control does not work. • Replace the batteries in the remote control. • Make sure RoboVac is turned on and fully charged.
Error Tones Wi-Fi Connection When RoboVac is in trouble, it will emit a series of short or long beeps and the red indicator on RoboVac will be solid or flashing. Before Wi-Fi setup, make sure RoboVac and your Wi-Fi network meet the following requirements. Flashing red indicator light Wi-Fi Setup Requirements Error Tone Cause One beep • RoboVac is stuck and one of the wheels is not making contact with the floor (hanging in mid-air).
Wi-Fi Status Light Cause Solid blue RoboVac has connected to your router, but cannot access the Internet. Rapidly flashing blue RoboVac cannot connect to your wireless router. Slowly flashing blue Wi-Fi connection is reset or has not been set up before. Solutions Customer Service • Check if your router is connected to the Internet. For FAQs and more information, please visit www.eufylife.com. • Check with your Internet provider to see if there is any Internet connection problem.