User Manual Motion Sensor Anker Innovations Limited. All rights reserved. eufy Security and eufy Security Logo are trademarks of Anker Innovations Limited, registered in the United States and other countries. All other trademarks are the property of their respective owners.
TABLE OF CONTENTS What’s Included 02 10 Specifications Product Overview 03 11 Notice Mounting the Motion Sensor 05 14 Customer Service English 01
WHAT’S INCLUDED PRODUCT OVERVIEW For Motion Sensor Installation Battery Compartment LED Indicator Motion Sensor T8910 Mounting Screws User Manual Motion Sensor SYNC Button Installing Batteries Welcome Card CR123A Battery 3M Adhesive Strip Remove the battery compartment lid on the Motion Sensor and insert the provided CR123A battery.
Adding Motion Sensor to Your System Note: 3. Make sure you've completed the setup of your eufy Security HomeBase. Follow the onscreen instructions on the Eufy Security app to add your motion sensor. 1. Choose Add Device, then select Motion Sensor to add it to your system. The LED indicator turns solid blue to indicate the pairing is successful.
No Pets 2-2.5 m 20° You can also install the motion sensor in your garage, dining room, or basement. Height and Tilt Angle To better detect the area where people may break in, rotate the motion sensor horizontally up to 30º. The motion sensor should be mounted 2m / 6⁴/₇ ft to 2.5m / 8⅕ ft above the floor with a tilt angle of preferably 20º downwards. If you have a large pet weighing more than 50 lb, change to a 10º downwards tilt.
Mount the Motion Sensor 1. There are two methods of mounting the motion sensor at the selected location: • Use the 3M adhesive strip: ① Snap the adjustable wall mount onto the motion sensor base. ② Stick the adhesive strip on the back of the sensor, remove the film, and stick the motion sensor on the wall. ③ Rotate the motion sensor to adjust the detection coverage. ② Drill holes at each marking. No need to drill a pilot hole in the wooden walls.
Replace the Battery When the motion sensor’s battery is low, the LED indicator shows as below. ou should replace the battery to keep the motion sensor working.
NOTICE FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
le brouillage est susceptible d'en compromettre le fonctionnement." This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. CUSTOMER SERVICE IC RF Statement Warranty When using the product, maintain a distance of 20cm from the body to ensure compliance with RF exposure requirements.