Use and Care Manual

Wire Your Switch

Disconnect wires from the old switch.

Turn o the circuit breaker. Then remove

the old wallplate of the wall switch and

label the wires.

Connect the wires to the smart switch as

shown below.

Note: No need to distinguish between Line and Load wires.

Ground: Usually green or copper.

Neutral: Usually white, not connected to the dumb switch.

Line/Load: Usually black, and connected to the dumb

switch.

If you are unsure, consult a qualied electrician.

Line up the switch with the mounting

holes. Secure it with screws.

Attach the wallplate. Then the wiring is

nished.

Set Up Your Switch

STEP 2

SET UP

Tap the button in the app and select Smart

Switches > Smart Switch HomeKit. Then

follow the step-by-step app instructions to set

up your smart switch.

DOWNLOAD APP

Get the Kasa Smart app from the App Store

or Google Play.

STEP 1

PAGE 1
Wire Your Switch 1 Turn off the circuit breaker. Then remove the old wallplate of the wall switch and label the wires. Set Up Your Switch 3 Connect the wires to the smart switch as shown below. Line up the switch with the mounting 4 holes. Secure it with screws. Attach the wallplate. Then the wiring is 5 finished. STEP 1 DOWNLOAD APP Get the Kasa Smart app from the App Store or Google Play. OR STEP 2 Tap the button in the app and select Smart Switches > Smart Switch HomeKit.
PAGE 2
Appearance Button Explanations Reset Restart On/Off Button LED Reset Restart Press and hold for about 5s until the LED blinks amber and green to reset Wi-Fi while keeping other settings. Press and hold for about 10s until the LED blinks amber to restore to factory default settings. Press to restart your switch. LED Status Solid amber Starting up. Blinking amber & green Ready for setup; Resetting Wi-Fi. Blinking green Connecting to Wi-Fi. Stay green for 30s Connected to Wi-Fi.