User's Manual

ManualsBrandsEtekcity ManualsElectronicsEtekcity Smart Body Weight Scale

Table Of Contents

14iB-001E R0

The product picture is indicative only. Appearance specifications please in kind prevail.

Start here!

Bluetooth Personal Scale

iB-1 SERIES Instructions for Use

ISO 9001 CERTIFIED BY SGS

Caution: The user is cautioned that changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-- Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be

installed and operated with a minimum distance of 20cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

Summary of content (4 pages)

PAGE 1
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
BATTERY INSTALLATION DEAR USERS: Thanks for using our Smart Bluetooth scale! To make sure data correctness and product service life, please read the instruction manual carefully before use, and keep for later reference. 2x1.5V AAA Battery ABOUT SENSSUN BLUETOOTH SCALE Bluetooth personal scales help you to store and keep track of your weight on your smart phone.
PAGE 3
AUTOMATIC SWITCH OFF Condition 2: if the unit switch is on the back of the scale, A. Find unit switch on the back of scale. B. Press the unit conversion button when scale Unit button Auto shut-off occurs after display shows the same weight reading for approximate a few seconds, if it is not in use. is power on, LCD shows current weight unit. Press the button again to convert weight unit. COMMON WARNING INDICATION REGULAR WEIGHING MODE After installing battery, place the scale on at oor.
PAGE 4
FAQ The software can't obtain weighing results from Bluetooth scale. ● Please confirm the Bluetooth icon on the software interface is in dark blue, showing connected successfully. ● Confirm the Bluetooth is on in your device. ● Confirm the Bluetooth scale is on within the valid range of signal coverage. ● Check the battery of Bluetooth scale, replace it if necessary. ● Restart your device and set up Bluetooth connection.