USB TOUCH SCREEN CONTROLLER USER’S MANUAL ET2055FP (ET2055FL) ET&T Technology Co., Ltd. 2F N0.2, Lane 57 Sec.1, Chien-Kuo N.Rd. Taipei,Taiwan,R.O.C. Tel: 886-2-2506-9472 Fax:886-2-2501-6877 E-Mail: etandt@seed.net.
WARNING Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of FCC Rules. These Limits are designed to provide reasonable protection against harmful interferfnce in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Table of Contents 1. Hardware Installation. 2. Software Installation. 3.
1. Hardware Installation. 1.1 Hardware Requirement 1) A PC with USB Port. 2) Touch Screen Controller ( ET2055FP、ET2055FL). 3) Touch Screen Panel. 1.2 Installation Note! Please turn off the power before following operation. 1) Fit in the Touch Screen accessories with monitor size. 2) To connect the controller and Touch Screen Panel. 3) Plug in Touch Screen USB controller to PC USB Port.
2. Software Installation 2.1 Preparation 1) Win98 operation system. 2) Win98 CD. 2.2 Installation 1) Boot up your system. 2) Insert driver diskette To A: 3) Place Win98 CD in CD Rom. 4) Following instruction step by step. 5) After completing driver installation, cursor will respond for touch on touch screen panel. 6) Please execute A:\setup.exe for adding calibration & swap button application for touch. Screen USB and let doubleclick more easy.
3. How To Use After setup up, Touch The Screen to let cursor move. Appendix Sepecification Resolution: of ET2055FP(ET2055FL). 12bit ADC TouchPanel Type: Interface: LED: 5-wire USB port Touch/Untouch indication Power: derived from USB port Power consumption: Dimension: Idle: 30mA Active: 35mA 79 x 38 x 21mm(ET2055FP) 3.11"x1.50"x0.83" 79 x 38 x 19mm(ET2055FL) 3.11"x1.50"x0.
