Installation Instructions

These devices comply with part 15 of the FCC rules, as well as the Canadian

Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:: (1) the device should not

cause harmful interference; and (2) the device must accept any interference

received. Including interference that may cause poor operation

Ce matériel est conforme à la partie 15 des règles FCC [et aux critères

d 'exemption des licences industrielles canadiennes (RSS)].L 'opération

doit satisfaire aux deux conditions suivantes: 1) l' équipement ne doit pas

causer d 'interférences nuisibles; et 2) l' équipement doit accepter toute

interférence reçue, y compris toute interférence pouvant conduire à des

opérations indésirables

Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operation in

conjunction with any other antenna or transmitter.

To maintain compliance with FCC’s RF Exposure guidelines, This equipment

should be installed and operated with minimum distance of 20cm from your body.

Pour se conformer aux directives de la Commission fédérale des communications

relatives à l 'exposition aux radiofréquencesLa distance minimale entre l'installation

et le fonctionnement doit être de 20 cm.