User's Manual

COMMUNICATION:
Up to 500m RF range (open air)
ECOP bi-directional radio protocol (onboard)
Modulation and Frequency: DSSS,
2
.
4
GHz
Specifications
The stand alone, 24x7, integrated, smoke detector. It features:
Product
Smoke Detector
ES800SK2
Integrated Smoke Detector
The We.R family creates a better home & family lifestyle experience:
User-friendly
Utilizes top-level technology
Fully RF wireless communication and battery operated
Easy to install, state-of-the-art design
Modulation and Frequency: DSSS,
2
.
4
GHz
SECURITY:
Tamper Alarm – when detached from base
Mechanism prevents installation with no battery
Buzzer operates even if the Control Panel is not functional
Data Security – 128bit AES encryption
Supports automatic over-the-air software upgrade (RSU) programming
and configuration
POWER CONSUMPTION:
Efficient power consumption to extend the operation period
Two AA-size Alkaline batteries
Over two years battery’s lifetime
SIZE and WEIGHT:
H: 46.7 mm, Diameter: 135 mm. Weight – 210 grams including
batteries.
ENVIRONMENT:
Storage range: -20
o
C – +50
o
C
Operating Ambient Temperature range with batteries: 0
o
C – +50
o
C
Humidity: Up to 85% non-condensing
CERTIFICATION:
EN14604
FCC ID:YXG-ES800SK2
Visual indication with tri-color LED where: Red – for smoke alarm,
Green – for power status and Yellow – for low battery/chamber
degradation
Test/Mute button
Powered by two AA-size Alkaline batteries
Siren emitted sound of 85dBA (from 3m)
Accessories: Double-sided adhesive tape
This device complies with FCC Rules Part 15 and with Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions:
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
Lifestyle
www.essence
-
grp.com/pages/WeR/Home
Certifications and approvals:
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the
party responsible for compliance (Essence Home & Family Ltd.) could void
the user’s authority to operate the equipment.
WARNING! To comply with FCC and IC RF exposure compliance
requirements, the device should be located at a distance of at least 20 cm
from all persons during normal operation. The antennas used for this
product must not be co-located or operated in conjunction with any other
antenna or transmitter.
Le dispositif doit être placé à une distance d'au moins 20 cm à partir de
toutes les personnes au cours de son fonctionnement normal. Les
antennes utilisées pour ce produit ne doivent pas être situés ou exploités
conjointement avec une autre antenne ou transmetteur.

Summary of content (1 pages)