User Manual Remote Control Model:VRF-DR
About the use of remote control lamp instructions and operating procedures: 1.2.4G part of the code, remote control distance of twenty-five meters. Every keystroke operation, LED signal two (right) will flicker. 2.At the same time, press and hold the power button ON and the brightness + button to turn ON the power, and the light will automatically blink five times. The code matching is successful. 3.According to the identification on the remote control: K1. Represents the switch light key, K2.
5.Wireless charging part When the remote control is placed on the charger, the remote control will automatically charge. LED signal one (left) will flash to indicate charging. Charging current:0.1-50mA Battery capacity: 70-90mA Charging voltage:3.8-4.5V Ambient temperature:-10 ~ 55℃ Wireless frequency:2426 - 2470MHz Modulation mode:GFSK Antenna gain:0 dBi The rest of the hardware is based on specifications and physical objects.
FCC Statement: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.