User Manual Please read this instructions carefully and keep it properly.
Product Parameter Name:Switch charger Model:VC720MV Input:AC 120-277V,50-60Hz Operation frequency:110-208kHz Modulation Type:ASK Antenna Gain:0 dBi Note: The above parameters are derived from the actual measurement of the product, the actual parameters will vary due to the product or other factors. Instructions 1. The blue LED indicator light will be on after power-on. 2. Put on the wireless receiving device that supports, enter the charging state after the product is aligned 3.
Matters needing attention 1. It is recommended to use a high-power adapter with18W above for better experience. 2. Please try to avoid placing metal objects on the contact surface during charging, such as patches, finger rings, metal protective shells, etc. 3. If you find intermittent charging or severe heating while charging, it is likely that the receiving coil of the wireless charging coil are not accurately aligned, and then perform the correct position alignment. 4.
5. When using, keep the ambient temperature at -20 to 55℃ as much as possible. Please avoid putting the product in water, fire, high (>55℃) and too low temperature (<-20℃) environment, and keep children away from accessories. 6. Please use a dry soft cloth to clean the surface and avoid cleaning with chemicals, soap or detergent. 7.
FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.