ESKY WIRELESS INC. ES820 Quick Start Guide V1.
Catalogue Version history .................................................................................................................................. 3 1. Structure Introduction .............................................................................................................. 5 2. Preparation.................................................................................................................................... 6 3. Quick Using Steps ............................................
Version history Version Data Note V1.0 2020.11.23 First version FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
The exposure standard employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with the EUT transmitting at the specified power level in different channels. The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines.
1. Structure Introduction 1. Positive 2. Negative 1.Screw holes 2.
2. Preparation Make sure the equipment below is all available.
3.
3.1 Power on ES82X 3.1.1 Insert SIM Card First you should prepare the Micro SIM Card, like below: Note: SIM Hot-Plug is forbidden for this device. After inserted the SIM Card,you will hear”ka”,it means the SIM Card is useful. When you insert the SIM card, before power on. Please see the below: 3.2 Switch on ES820 When finishing installation, switch on the device, it will start works. Note: The device can be charging by USB cable. Then, please check LEDs status.
Note: If you want to test all the commands via SMS, please refer to Step 3, Step 4 and Step 5. Or if set command by USB (AT), please refer to step 7, step 8. 3.3 Set APN, Report Server IP (SMS) The command to re-set server IP is “DATA”. The format of “DATA” is shown below. Content Command Code Separator Parameter3 End Sign Explanation DATA , URL: PORT # For example: The reporting server is esky car online platform: www.eskylocate.com and the port is 1750. So the content of SMS should be: data,www.
Make sure SIM supports SMS service. Try to use the SIM card send SMS by your mobile phone. Make sure GSM coverage is good. 3.4 Set APN (SMS) The command to re-set APN is “APN”. The format of “APN” is shown below.
3.5 Set other commands by SMS You can set others commands by SMS. Like this: version, mode, factoryreset ect. Please check the ES82xProtocol. 3.6 Set APN, Report Server IP (AT) Note: AT command is based on the command in . The command to re-set server IP is “DATA”. The format of “DATA” is shown below. Content Command Code Separator Parameter3 End Sign Explanation DATA , URL: PORT # For example: The reporting server is esky car online platform: www.eskyloacte.
Try again Please don’t set any command within 1 ~ 2 min after ES82X is powered on. Mark sure DATA command spells correctly. ③ ERROR Make sure that AT command mark spells correctly. ④No response. Type “enter” again. Re-type DATA command again without pause 3.7 Set APN (AT) Note: AT command is based on the command in . If you are not in China or America, APN is necessary to change. The command to re-set APN is “APN”. The format of “APN” is shown below.
And the response result please refer to the DATA(AT) command. 3.8. Normal Function Test (AT) Since AT command is based on commands in , so you can choose whatever command you want to test by AT command. All you need to do is add AT command mark. 4. Supplement 4.1 LED Indication Yellow LED indicates LTE Net status. Green LED indicates GPS status. Red LED indicates charging status.