TABLE OF CONTENTS 1‐ 2‐ 3‐ 4‐ 5‐ 6‐ 7‐ 8‐ P ixMob Broadcaster F CC Statements I C Statements M aterial needed I nstallation B roadcaster menu T roubleshooting B roadcaster characteristics Page Page Page Page Page Page Page Page 2 4 5 6 7 8 10 11 PixMob Broadcaster 1
1. P ixMob Broadcaster A Broadcaster is a Bluetooth transmitter that controls PixMob luminous objects wirelessly. Similarly to a LED flood light, it is controllable by a lighting board through DMX .
1. 2. 3. 4. 5. 6.
2. FCC Statements FCC ID: 2ADS4BRO1 This device complies with part 15.247 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
3. IC Statements IC: 7254ABRO1 This device complies with Industry Canada licenceexempt RSS 247 standard. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS 247.
4. Material needed 1. Bluetooth a ntenna ( Male “N” type connector) 2. DMX XLR 5 pin cable 3. PixMob Broadcaster 4.
5. Installation This picture shows the different connections of the Broadcaster. Broadcasters can also be connected in a daisychain by connecting DMX OUT to DMX IN of the next Broadcaster and AC OUT to AC IN of the next Broadcaster. Note: The equipment will be professionally installed • For electrical reasons, do not connect more than 10 Broadcasters in a daisychain.
6. Broadcaster menu a. Home screen When powering up, the Broadcaster will display the relevant version information. For example here, we have: Revision 1.6.
b. Broadcaster interface On the right side of the control display are four control buttons. Next to the control buttons are four LED status indicators. The LED status indicators blink whenever the Broadcaster has incoming DMX , outgoing RF or Ethernet communication. There is also a LED indicator for p ower . Note that the blinking speed of the green DMX LED depends on the frame rate of the DMX signal received .
d. Setting u p D MX a ddress To set up a DMX address , put the cursor on the “ Address ” line, press ENTER and set the address using UP and DOWN. Once the proper address is set, press ENTER to save the changes. e. Silence request A silence request is automatically sent when the Broadcaster is transmitting. This request has priority over the Sparks applications for the signal sent to the PixMob wristbands. 7.
8. Broadcaster characteristics FREQUENCY BAND: RF POWER MAX(W): TYPE OF MODULATION: POWER REQUIREMENTS: ANTENNA INFORMATION: 2400–2483.5 MHz Conducted 1 W GFSK 120/220VAC 50/60Hz Gain 4.9 dBi. The EUT is professionally installed. BODY DIMENSION : WEIGHT : COLOR : 22.2 cm x 21 cm x 8.7 cm (L, W, H) 3.