User's Manual

ManualsBrandsEsel International ManualsElectronicsPS2 Wireless Controller Host

How to use:

Step 1: Insert the controller's receiver into the Player 1 slot

Note:

- Do not insert the controller's receiver into a memory card slot.

- Switch off the console before inserting the controller's receiver. Once the

receiver is inserted you may turn on your console.

Step 2: When the receiver is first plugged into the console, the LED is OFF.

Once the controller has detected the receiver, the LED on the receiver will

turn ON. The controller is now ready to use.

Note:

When using more than one wireless controller, you can only plug one receiver

in at a time. When the LED lights up on the first receiver you can then plug

in the second wireless receiver into the next available controller port.

Force Connection to a designated Controller and Receiver:

Forcing the connection to a designated controller and receiver can be achieved

by following the steps listed below:

a) Press the FC button on the receiver - the LED on the receiver starts to

blink.

b) Press and hold the Select and L3 button simultaneously on the controller.

The LED of the receiver stops to blink and lights up. The force connection

is complete and you are ready to play.

c) Controller's receiver

Battery Replacement:

- Open the battery compartment door.

- Insert the batteries as marked on the bottom of the battery compartment.

- Close the battery compartment door. You are now ready to use your wireless

controller.

Note:

- For longer playing time, use Alkaline batteries.

- Do not mix fresh and used batteries. This will reduce the controller's

transmitting and receiving distance and may cause the product to malfunction.

- Rechargeable batteries can be used with this product (rechargeable batteries

are not included).

- Dispose of used batteries according to the battery manufacturer's instructions.

Thank you for purchasing Hip Gear's 2.4G Wireless Controller for all PlayStation

consoles. Please read this manual carefully before use.

Features:

- Fully compatible with all PlayStation consoles (PS2, PSOne and PSX)

- Dual vibration motors

- Power on/off selection

- Twin analog sticks

- Rubber grips

- Auto player matching

- 10 Meters(30ft) 2.4G RF wireless transmitting & receiving distance

- Turbo fire setting

- Macro programmable setting

- Low power Indicator

Button Name for Hip Gear's 2.4G RF PS2 Wireless Controller:

a) Controller (front view)

b) Controller (top view)

PS2 2.4G Wireless Controller

compatible with PlayStation, PSone and PlayStation2

TURBO

MACRO

SELECT

START

MODE

POWER ON/OFF

FUNCTION

D-PAD

FIRE BUTTONS

FORCE CONNECTION

BUTTON

LED

Force Connection

Button

LED

Summary of content (2 pages)

PAGE 1
PS2 2.4G Wireless Controller compat i bl e w i t h P l ayS t at i on, P S one and P l ayS t at i on2 c) Controller's receiver How to use: Step 1: Insert the controller's receiver into the Player 1 slot FORCE CONNECTION BUTTON Thank you for purchasing Hip Gear's 2.4G Wireless Controller for all PlayStation consoles. Please read this manual carefully before use.
PAGE 2
Caution: If the controller is left idle for more than 3 minutes the designated connection may be lost. If this happens, simply repeat the steps above. Mode Button: The Mode button is used for selection of Digital or Analog modes. The LED is OFF - Digital The LED is ON - Analog To Clear a Turbo Fire: - Press and hold the Turbo Fire button, the Function LED lights up. - Press the button which has been set to Turbo Fire, the LED turns off.