User's Manual

WARNING! This module is to be installed only in ESCORT Inc. end
products by ESCORT Inc. personnel, and shall not be offered to
3rd party OEM integrators or the general public.
Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
To comply with FCC RF exposure limits for general population/uncontrolled exposure,
the antenna(s) used for this transmitter must not be collocated or operating in
conjunction with any other antenna or transmitter.
The RF Module is labeled with its own FCC ID Number. If the FCC ID is not visible when
the module is installed inside another device, then the outside of the device into which
the module is installed must also display a label referring to the enclosed module. This
exterior label can use wording such as the following:
Contains Transmitter Module FCC ID: QKLBT2