Cautions and Warnings * READ THIS ENTIRE MANUAL CAREFULLY BEFORE BEGINNING INSTALLATION. SAVE THESE INSTRUCTIONS. * Use only Watson replacement parts. ยป To reduce the risk of personal injury, attach the fan directly to the support structure of the building according to these instructions, and use only the hardware supplied. * To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location.
Parts Inventory Carefully open the packaging. Remove items from Styrofoam inserts. Remove motor housing and place on carpet or Styrofoam to avoid damage to finish. Check against parts inventory that all parts have been included.
Installation Preparation From Wall or Nearest Obstruction To prevent personal injury and damage, ensure that the hanging location allows the blades a clearance of 2.3m from the floor and 76cm from any wall or obstruction. Be sure the outlet box is securely attached to the building structure and can support the full weight of the fan. Preparing the Fan Site Down rod Installation This fan can be mounted with a drown on a normal or vaulted ceiling. The hanging length can be extended by a longer drown.
Ste pl: Installing the Hanger Bracket AN Wood Ceiling TN concrete Ceiling Please drill $8mm hole on the concrete ceiling, and insert the bolt. Align bracket with the hole, then tighten with nut.
Step: Assembling and Hanging the Fan electrical wiring hanging ball slot R clip Adapter L yoke set screw If you wish to extend the hanging length of your fan, you must remove the hanging ball from the 6 inch down rod provided to use with an extended down rod (included) . (If you wish to use the 6 inch down rod, please proceed to instructions below.) To remove hanging ball, loose set screw on hanging ball and remove pin and clip. Lower hanging ball and remove stop pin.
Step: Remote control connection DC: green/yellow stripe Ground green/yellow stripe wire L L o N input N (white) Remote control receiver Neutral N (White) Light L (blue) Grey DC motor L Pink DC motor L Bad rr rr 2 Red DC motor L Receiver place:
Step: Canopy Assembly ok Raise canopy to hanging bracket, aligning loosened screws in hanging bracket with slotted holes in canopy. Twist canopy to lock. Re-insert screws and secured all screws with screwdriver. With hanging bracket secured to the outlet box and able to support to fan, you are now ready to hang your fan. Grab the fan firmly with two hands. Slide down rod through opening in hanging bracket and let hanging ball rest on the hanging bracket.
Step: Installing Light Kit Take down the three screws from connect plate of motor,please tidy up all the wires carefully into connect plate.Assemble and align the holes on the back of LED light to the three screws on the connect plate of motor, please see the Then screw the three screws tightly from hole on the LED plate, please make sure the light kit can't be moved after screwing. Restore the cover and the lamp shade back to the LED pan.
Step: Decorative Pan Inventory Restore the cover and the lamp shade back to the LED pan, and secure them with decorative clips and bolt nuts.