Quick start guide
What's included Light arc E1 by Ericsson Gateway Router Power adapter Ethernet cable Hardware specifications: • 802.
1 Install the included nano-SIM card, or plug in the Ethernet cable into the E1 Gateway Router’s WAN port. 2 Connect the power supply Plug the power adapter into a power outlet, and plug the other end into the power port on the underside of the router. The router is ready to use when the light arc stops flashing and blue light begins pulsing on and off. To install the nano-SIM card: Use a Phillips head screwdriver to unscrew the SIM card slot cover.
3 Select a Wi-Fi network * The default SSID’s (network names) are: Ericsson_[last 4 digits of serial number]_2.4G Ericsson_[last 4 digits of serial number]_5G_1 Ericsson_[last 4 digits of serial number]_5G_2 Advanced router settings To improve the security of your wireless networks, consider changing the SSID’s and passwords to something different than the default. This can be done through advanced router settings.
* Advanced router settings (cont’d) 2. Open an internet browser window, type in the IP address: 192.168.1.1, and complete the search by pressing Enter or Return on your keyboard. Alternatively, you can search for: http://E[router-serial-number] (i.e. http://EDU00001234/ ) 3. Log in using the default username and password: Default username: root Default password: ericssonxxxx xxxx = Last four digits of the E1 Gateway Router’s serial number. (e.g.
Frequently asked questions How do I change the Wi-Fi SSID (network name) and password? 1. Log into advanced router settings, choose Network from the list on the left, and then click Wifi from the list that appears under Network. 2. Find the network you want to edit, and click EDIT. 3. To change the network name, look for the Interface Configuration section. There, under the General Setup tab, you will see a space labeled SSID where you can type in a new network name of your choosing.
4. To change the password, click the Wireless Security tab. There you will see a space labeled Key where you can type in a new password of your choosing. (Be sure to write it down in case you forget it later.) How do I configure LTE/5G? Log into advanced router settings, choose Network from the list on the left, then click LTE Configuration. Here you can confirm the SIM, APN, and IMEI are correct. How do I access LTE/5G information? 1.
Reset to factory settings What do the lights on the E1 Gateway Router mean? There are two ways to reset the E1 Gateway Router to factory settings. The E1 Gateway Router communicates its status using different LED displays. Hardware method Press and hold the Reset button located on the base of the router for ten seconds. Status LED display Booting Seven colors cycle the light arc. Networking connecting Green light blinks three times. System ready Blue light pulses on and off.
Reset to factory settings (cont’d) Update firmware Interface method 1. Log into advanced router settings, choose System from the list on the left, then click Reboot/Reset. 2. Select PERFORM FACTORY RESET. Check with E1 Customer Support to get a link to a validated router firmware image. Download the firmware image and then upload it to advanced router settings. The router will reset to factory default settings and reboot automatically. The process takes about two minutes. To upload: 1.
LZT 138 2288
