BRU3 Mechanical Design Contents 1 Hardware Description.................................................................................. 3 1.1 Introduction ...................................................................................... 3 2 Base Radio Unit 3 - BRU3 .......................................................................... 4 2.1 FE Computer Board - FCB .............................................................. 6 2.2 FE Power Supply Unit - FPU.......................................
BRU3 MANUAL The contents of this document are subject to revision without notice due to continued progress in methodology, design and manufacturing. Ericsson shall have no liability for any errors or damages of any kind resulting from the use of this document. BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 1 Hardware Description 1.1 Introduction 3 (36) This section describes the hardware units included in the Base Radio Unit BRU3. The section is not intended to be used as a service handbook, but it gives the user a good knowledge of the hardware structure of the Base Radio Unit. BRU3 MANUAL, Doc.
(36) 2 BRU3 MANUAL Base Radio Unit 3 - BRU3 Designation Frequency band BRU39xx 900 MHz BRU38xx 800 MHz BRU34xx 400 MHz For a list of all frequency bands, please refer to the Introduction and Product Specification section in the BRU3 - General module. Design BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 5 (36) Art.No.
(36) 2.1 BRU3 MANUAL FE Computer Board - FCB Designation Article number FE Computer Board, FCB ROAA 219 711 Connectors Pos. Connector Connection (1) P1 Radio Connector (2) P2 Connection Board Connector (3) P3 Power Connector (4) P4 Modem Connector (5) P5 Expansion Connector LEDs Pos. LED Colour Function (6) Watchdog alarm Red Lit when the Watchdog is released (7) Status indicator Yellow Lit when the processor is operating OK Switches Pos.
BRU3 MECHANICAL DESIGN Design BRU3 MANUAL, Doc.
(36) BRU3 MANUAL 2.2 Pos. FE Power Supply Unit - FPU Designation Article number 34xx: FE Power Supply Unit; FPU BMKA 071 003/1 38xx: FE Power Supply Unit; FPU BMKA 071 003/3 39xx: FE Power Supply Unit; FPU BMKA 071 002/3 (1) 34xx: FE Power Supply Board, FPB ROAA 117 2165 (1) 38xx: FE Power Supply Board, FPB ROAA 117 2165 (1) 39xx: FE Power Supply Board, FPB ROAA 219 710 Connections Pos.
BRU3 MECHANICAL DESIGN 9 (36) LEDs Pos. LED Colour Function (7) L1, Mains Yellow Incoming 120/230 AC OK (8) L2, +14V Yellow +14 V DC to the radio unit and DC/DC modules OK (9) L3, Error Red Sum alarm, unspecified power failure in FPU Fuses Pos. Fuse Type Function (10) F1 6.3AT, Glass fuse, 5*20 mm Power to FHU (11) F2 6.3AT, Glass fuse, 5*20 mm Power to FHU and FPB (12) F3 6.3AF, Glass fuse, 5*20 mm Power to/from FBU BRU3 MANUAL, Doc.
(36) BRU3 MANUAL Design BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 2.3 11 (36) FE Battery Unit 4Ah - FBU Designation Article number FBU - FE Battery Unit BKBA 071 001/1 Included units Article number Pos. Designation (1) FE Battery Packet BKCA 509 0001/01 (2) Battery cassette SXAA 138 0426 Pos. Connector Type Connection (3) Power supply Molex Power Connection Connections BRU3 MANUAL, Doc.
(36) BRU3 MANUAL Design BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 2.4 FE Connection Board - FNB Designation Article number FNB - FE Connection Board ROAA 219 713 Connections Pos. Connector Type (1) P1, CONSOLE Port 9-pole, DSUB Male (2) P2, ALARM Port 9-pole, DSUB Female (3) P3, TEL Connection 9-pole, DSUB Female (4) P4, RS232-MOX Port 25-pole, DSUB Male (5) P5, RS422-MOX Port 25-pole, DSUB Male (6) P6, Connection FNB - FCB Design BRU3 MANUAL, Doc.
(36) BRU3 MANUAL Pin ID P1, CONSOLE Port Pin Signal Interface/function 1 GND Chassis GND 2 RXB RS232 / Receive data to FNB 3 TXB RS232 / Transmit data from FNB 4 “+12V” RS232 / “high” signal 5 SGND 12ohm rel. chassis GND / Signal GND 6 - 7 BOOT 8 - 9 - RS232 / State signal to FNB P2, ALARM Port Pin Signal Interface/function 1 VCC_EXT +12V, Max. 40mA, serial res. 100ohm / Port 1 2 AL1+ Max. 10mA, serial resistance 8kohm / Port 1 3 AL1- Max.
BRU3 MECHANICAL DESIGN Pin Signal Interface/function 6 SWA 2-wire switched line part A 7 SWB 2-wire switched line part B 8 - 9 - P4, RS232-MOX Port Pin Signal Interface/function 1 GND 2 TXA RS232 / Transmit data from FNB 3 RXA RS232 / Receive data to FNB 4 RTS RS232 / Request to send from FNB 5 - 6 - 7 SGND 12ohm rel.
(36) BRU3 MANUAL P5, RS422-MOX Port Pin Signal Interface/function 1 GND Chassis GN 2 TX_A RS422 / Transmit data inverted from FNB 3 RX_A RS422 / Receive data inverted to FNB 4 RTS_A RS422 / Request to send inverted from FNB 5 - 6 - 7 SGND 12ohm rel.
BRU3 MECHANICAL DESIGN 2.5 17 (36) FE Modem Board - FMB The modem equipment consists of two separate boards: Designation Article number FMB - FE Modem Board ROAA 219 712 Connections Pos. Connector Connection (1) P1, FMB interface Connector FMB interface towards the FAB Design BRU3 MANUAL, Doc.
(36) 2.6 BRU3 MANUAL FE Adaptation Board - FAB Designation Article Number FAB - FE Adaptation Board 39xx ROAA 219 714/1 38xx ROAA 219 714/6 34xx ROAA 219 714/2 34xx ROAA 219 714/3 34xx ROAA 219 714/5 Connections Pos. Connector Connection (1) P1, Modem connector Modem connection to FMB (2) P2, Telephone connector Telephone connection BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN Design BRU3 MANUAL, Doc.
(36) 2.7 BRU3 MANUAL FE Radio Board - FRB Designation Article Number FRB - FE Radio Board 39xx ROA 117 2005 39xx ROA 117 9842/1 38xx ROA 117 9842/3 34xx ROA 117 2015/1 34xx ROA 117 2015/2 34xx ROA 117 2015/3 Connections Pos. Connector Type Connection (1) RX Coax Antenna input (2) TX Coax Antenna output BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 21 (36) Design, 39xx ROA 117 2005 21/2882-LZE 401 197 Rev A Design, 38xx ROA 117 9842/3, 39xx ROA 117 9842/1 BRU3 MANUAL, Doc.
(36) BRU3 MANUAL Design, 34xx ROA 117 2015/2 Design, 34xx ROA 117 8896 19/1424-LZE 401 204 A 2 1 BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 2.8 FE Filter Module - FFM Designation FFM - FE Filter Module Article Number 39xx-D KRF 201 129/1 39xx-T KRF 201 165/1 38xx-D KRF 102 137/1 34xx-T KRF 201 124/1 34xx-T KRF 201 124/2 34xx-T KRF 201 124/3 34xx-T KRF 201 124/4 34xx-T KRF 201 124/5 34xx-T KRF 201 124/7 34xx-D KRF 201 164/1 34xx-D KRF 201 164/2 34xx-D KRF 201 164/3 34xx-D KRF 201 164/4 34xx-D KRF 201 164/5 34xx-D KRF 201 164/7 BRU3 MANUAL, Doc.
(36) BRU3 MANUAL Included Units Pos. Designation (1) Mounting plate (2) RXBP-Filter (Duplex) (3) TXBP-Filter (Duplex) Pos. Connector Type Connection (4) RX Coax Antenna input to FRB (5) TX Coax Antenna output to FRB (6) RX Coax Antenna output (7) RX/TX Coax Antenna connector Design BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 25 (36) Design TX BP 800 MHz/ BP 900 MHz RX 21 22 TXBP FILTER RXBP FILTER RX TX Connected to FRB TX DPX 800 MHz/ BP 900 MHz RX 21 22 TXBP FILTER RXBP FILTER RX TX Connected to FRB TX BP 900 MHz RX 21 22 Connected to FRB TXBP FILTER RXBP FILTER RX TX DPX 900 MHz 21 RX 22 Connected to FRB TXBP FILTER RXBP FILTER RX TX BRU3 MANUAL, Doc.
(36) BRU3 MANUAL Design BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 2.9 27 (36) FE Heating Unit - FHU Designation Article number FE Heating Unit, FHU BPCA 801 01/1 (120/230 V AC, 300 W) BPC 105 02 (120/230 V AC,600 W) BPC 105 03/1 (230 V AC,600 W) BPC 105 03/2 (120 V AC,600 W) Connector Pos. Designation (1) Input Connector for Heater Design FHB - BPC 105 02 BRU3 MANUAL, Doc.
(36) BRU3 MANUAL Design FHB - BPCA 801 01/1 Design FHB - BPC 105 03/1 and /2 BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 2.10 Cables 2.10.1 FE Cable Set - FCS, TSRA 909 0105 29 (36) FE Computer Board, FCB - FE Power Supply Board, FPB - FE Battery Unit, FBU BRU3 MANUAL, Doc.
(36) BRU3 MANUAL BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 2.10.
(36) 2.10.3 BRU3 MANUAL FE Console Cable, TSRA 902 0190 BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 2.10.4 FE Modem Connection Cable RS 232, TSRA 904 63 BRU3 MANUAL, Doc.
(36) 2.10.5 BRU3 MANUAL FE Modem Connection Cable RS 422, TSRA 904 64 BRU3 MANUAL, Doc.
BRU3 MECHANICAL DESIGN 2.10.6 FE Alarm Cable, TSRA 905 44 BRU3 MANUAL, Doc.
(36) 2.10.7 BRU3 MANUAL FE Telephone Line Connection Cable, TSRA 905 45 BRU3 MANUAL, Doc.