User's Manual

ManualsBrandsEricsson-LG ManualsElectronicsIP Phone

E-911 and This Phone’s Use with Multi-Line Telephone

Systems

Please note that the use and operation of this phone as

part of a multi-line telephone system (MLTS) may be sub-

ject to state and/or federal E-911 MLTS laws that require

the MLTS to provide a caller’s telephone number, exten-

sion, and physical location to applicable state and/or lo-

cal emergency services when a caller initiates a 911 call.

This phone does not provide a caller’s telephone number,

extension, or physical location information to emergency

services when a caller dials 911, and compliance with state

and/or federal E-911 MLTS laws is the sole responsibility of

the purchaser of this phone.

Regulatory Information and Disclaimers

“Privacy of communications may not be ensured when us-

ing this telephone”.

Any changes or modiﬁcations made to this device that are

not expressly approved by the manufacturer may void the

user’s authority to operate the equipment. The Manufactur-

er is not responsible for any radio or television interference

caused by unauthorized modiﬁcation of this device, or the

substitution or attachment of connecting cables and equip-

ment other than those speciﬁed by the manufacturer. It is

the responsibility for the user to correct any interference

caused by such unauthorized modiﬁcation, substitution or

attachment.

The manufacturer and its authorized resellers or distribu-

tors will assume no liability for any damage or violation of

government regulations arising from failure to comply with

these guideline.

Pursuant to Part 15 of the Federal Communications

Commission(FCC) Rules, the user is cautioned that chang-

es or modiﬁcations not expressly approved by LG-Nortel.

Could void the user’s authority to operate this equipment.

Important Safety Instructions

USA-FCC (Federal Communications Commission)

Statement

This device complies with Part 15 of the FCC Rules. Op-

eration is subject to the following two conditions:

FCC Interference Statement

Note: This equipment has been tested and found to com-

ply with the limits for a Class B Device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses

and can radiate radio frequency and, if not installed and

used in accordance with the instructions, may cause harm-

ful interference to radio communications. However, there

is no guarantee that interference will not occur in a par-

ticular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or

more of the following measures:

Compliance Statement for Canada

This Class B digital apparatus complies with Canadian

ICES-003.

Cet appareil numérique de la classe B est conforme à la

norme NMB-003 du Canada.

This device complies with Class B Limits of Industry Cana-

da. Operation is subject to the following two conditions;

European Union Declarations of Conformity

LG-Nortel Co. Ltd. declares that the equipment speciﬁed in

this document, which bears the “CE” mark, conforms to the

European Union Radio and Telecommunications Terminal

Equipment Directive (R&TTE 1999/5/EC), including Elec-

tromagnetic Compatibility Directive (2004/108/EC) and

Low Voltage Directive (2006/95/EC).

The product fulﬁlls the essential requirements of the har-

monized standards shown above.

Product Safety Instructions

This product complies with and conforms to the following

international Product Safety standards as applicable:

Safety of Information Technology Equipment, IEC 60950-1,

including Relevant national deviations as listed in Compli-

ance with IEC for Electrical Equipment (IECEE) Safety of

Information Technology Equipment, CAN/CSA-C22.2 No.

60950-1/UL 60950-1

Regulatory and Safety Information

Please save these instructions and read carefully

P/NO: MMBB1234567,1.0

This device may not cause harmful interference, and

This device must accept any interference received, in-

cluding interference that may cause undesired opera-

tion.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

receiver.

Connect the equipment into an outlet on a circuit differ-

ent from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV techni-

cian for help.

This device may not cause harmful interference, and

This device must accept any interference received, in-

cluding interference that may cause undesired opera-

tion.

Before connecting or using your new phone, take a

moment to consider safety and reliability. Use common

sense when locating, connecting and using you Phone.

Locate on a dry level surface away. Keep the phone away

from the edges of the surface to avoid the potential of

a fall.

Locate cables to avoid potential for damage. For exam-

ple, do not locate under rugs or carpet as damage may

result from foot trafﬁc or heavy objects. Also, do not lo-

cate cables between the desktop and walls where they

may be crushed, damaging the insulation.

Check the cables regularly and, if damage is noted, dis-

connect your phone. Contact your local representa-tive

for a replacement.

Should liquid spill on the phone, disconnect the unit from

power and the network.

Do not use during lightning storms. Lightning presents a

potentially lethal shock hazard.

Clean the phone with a soft dry cloth; do not use liquid

cleaners.

Always use caution when connecting to AC power. Use

only with a properly grounded standard AC power outlet.

•

Regulatory and Safety Information 1.0.indd 1Regulatory and Safety Information 1.0.indd 1 2008-01-24 오후 3:14:552008-01-24 오후 3:14:55

Summary of content (5 pages)

PAGE 1
Regulatory and Safety Information Please save these instructions and read carefully USA-FCC (Federal Communications Commission) Statement E-911 and This Phone’s Use with Multi-Line Telephone Systems This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and 2 This device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
IP8830 Series Quick Installation Guide This document provides information about the IP8820, IP8830, and IP8840. You can download all required documents at www.lg-nortel.com. Before you start If you require a Global Power Supply for your IP Phone, use the LG-Nortel approved global power supply. Package contents The following items are included in your IP8800 Series package. Before installation, ensure that you have the following package contents: • IP Phone (IP8830) • Foot Stand • Handset Cord • 2.
PAGE 3
For more detailed installation instructions, see IP8820/IP8830/IP8840 Installation at www.lg-nortel.com. Connecting Handset and Headset 2 1 Plug one end of the handset cord (short straight section) 1 into the handset. 2 Plug the other end of the handset cord (long straight sec- 3 tion) into the handset jack on the back of the IP Phone marked with the symbol. Wiring Channel 3 (Optional) Plug one end of the cord into the headset jack on the back of the IP Phone marked with the symbol.
PAGE 4
Expansion Modules for IP8830 Series This document provides information about the LCD Expansion Module: 12-Key Self-Labeling and the LED Expantion Module: 12-Key Paper Label. You can download all required documents at www.lg-nortel.com. Your Expansion Modules LCD Expansion Module: 12-Key Self-Labeling LED Expansion Module: 12-Key Paper Label Descripton The Expansion Modules for IP Phone 8800 Series provide 12 additional line/programmable feature keys for your IP Phone.
PAGE 5
Attaching the foot stands Set the Expansion Module and IP Phone foot stands to the same angle. 1 Align the Top tabs on the foot stands with the slots on the back of the Expansion Module and IP Phone. 2 And then, move the foot stands upward until it clicks into 2 Top Tabs place. For more detailed installation instructions, see the IP8800 Series Quick Installation Guide. 1 Foot stands Completing the installation 1 Connect power to the IP Phone. The IP Phone and Expansion Modules power up.