User's Manual

ManualsBrandsEricsson-LG ManualsElectronicsDECT fixed base part of ket telephone system

ipLDK-60 Hardware Description and Installation Manual Issue 2

TERMINAL CONNECTION AND WIRING METHOD July, 2010

6.3 Base Station Installation

Figure 6.3.1 GDC-400B, GDC-600B(Europe Models)

Figure 6.3.2 GDC-600BE(USA/Europe Model)

There are two ways in installing the base station:

Mounting Base Station - 1

The weight of a base station is light as approx. 460g, so it can be mounted on a masonry or dry-wall surface, wooden

wall, or partition wall. The distance between mounting holes is 121mm as shown below. The base station is mounted

with 1 1/2 inch or longer screws. Drill pilot holes in the two locations, insert the screws and tighten leaving about 3mm

gap between the wall and screw head. Mount the base station on the screws and tighten the screws securely.

Before mounting base station permanently, you should determine locations that provide the best coverage. The wall

mounting procedure of a base station is as follows:

1. Drill two 3.5mm holes in a fixed wall. To properly position the holes, you can use mounting template that is the la

st sheet of this manual and copy it if necessary.

2. Insert anchors into the drilled holes. Then insert screws in the anchors, leaving a 3mm gap between the wall and

screw head.

3. Mount the base station eyelets on the screws.

Summary of content (4 pages)

PAGE 1
ipLDK-60 Hardware Description and Installation Manual TERMINAL CONNECTION AND WIRING METHOD Issue 2 July, 2010 6.3 Base Station Installation Figure 6.3.1 GDC-400B, GDC-600B(Europe Models) Figure 6.3.2 GDC-600BE(USA/Europe Model) There are two ways in installing the base station: Mounting Base Station - 1 The weight of a base station is light as approx. 460g, so it can be mounted on a masonry or dry-wall surface, wooden wall, or partition wall.
PAGE 2
ipLDK-60 Hardware Description and Installation Manual TERMINAL CONNECTION AND WIRING METHOD Figure 6.3.
PAGE 3
ipLDK-60 Hardware Description and Installation Manual TERMINAL CONNECTION AND WIRING METHOD Issue 2 July, 2010 Mounting Base Station - 2 (Using Wedge) Installing the Base Station using the wedge, 1. Determine at first the location on wall where the wedge prepared for mounting the base station is to be fixed. 2. The wedge should be settled by using two screws on the wall with mounting template. 3. And insert the base station pulling down into the wedge. Figure 6.3.
PAGE 4
ipLDK-60 Hardware Description and Installation Manual TERMINAL CONNECTION AND WIRING METHOD Issue 2 July, 2010 6.3.1 Installation of the Ferrite core and wiring Ferrite core is provided in the package of Base station for EMI. Ferrite core should be installed when WDIB4 is installed in the key telephone system. One Ferrite core in the package of base station is for line cord between base station and each port of WDIB4. Figure 6.3.5 Simple direct cable connection Figure 6.3.