User's Manual

User Manual for Intelligentdeodorizer

CW-BT01

Thank you for purchasing our product, for better experience, please read

carefully the above content and keep it properly.

The product is compatible with Mi Home App.

To connect with Mi Home, firstly please download and install Mi Home,

You can search Mi Home in app store to finish the step. Mi home users will

be lead to the device-connecting page by scanning the QR code in product.

Scan the QR code in product

●Add device

1.Long press the switch for 5 seconds to start the device-connecting step

(during connecting, the blue light will be on and flowing. After connected,

the blue light will be on and last for 5 secs.)

2.Open Mi Home and log in your account

3.Click the “+” in the upper right corner of the app, you’ll go to the

add-devices page

4.Click “ ” in the upper right corner of the page, scan the product

QR code and finish the step by guidance.

Notes: In case the QR code is not able to be scanned, you can add the device

by searching product name.

●As Mi Home will be updated from time to time, the actual operation might

have little differences, please follow Mi Home’s guidance to finish all

steps.

1.Product introduction

PAGE 1
User Manual for Intelligentdeodorizer CW-BT01 Thank you for purchasing our product, for better experience, please read carefully the above content and keep it properly. The product is compatible with Mi Home App. To connect with Mi Home, firstly please download and install Mi Home, You can search Mi Home in app store to finish the step. Mi home users will be lead to the device-connecting page by scanning the QR code in product. Scan the QR code in product ●Add device 1.
PAGE 2
.Use Instruction 01.Fresh mode Click the switch once to start the fresh mode 02.Anion Mode Click the switch twice to start the anion mode 03.Deep deodorize mode Click the switch three times to start the deodorize mode 04.Battery indicator Click the switch four times to check the battery capacity. If the indicator is blue and always on, means the powers’ sufficient. If the indicator is red and always on, means the powers’ not enough. 05.Install the hook Install the hook in the hook hole if needed 3.
PAGE 3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.