User manual

TB-7Z-020-EMC Hardware User Manual

Rev.1.03

1. Related Documents and Accessories

Related documents:

All documents relating to this board can be downloaded from our website. Please see attached paper on

the products.

Accessories.

- RS-232C/CAN Bus Cable x1

- microSD card 4GB x1

- Power Supply(DC-12V) x1

- DC Switch Cable x1

- Spacer Set

2. Overview

The TB-7Z-020-EMC evaluation board for the Zynq™-7000 All Programmable SoC provides a hardware

environment for developing and evaluating designs targeting the Zynq™-7000 XC7Z020-1CLG484. The

TB-7Z-020-EMC provides features common to many embedded processing systems, including DDR3

SDRAM component memory, a 10/100/1000 Ethernet PHY, general purpose I/O, a DVI Transmitter, a

USB OTG 2.0 Port, a Pmod interface, a CAN interface and a UART interface. Other features can be

supported using VITA-57 FPGA mezzanine cards (FMC) attached to either of two low pin count (LPC)

FMC connectors.

3. Feature

Zynq-7000: Xilinx XC7Z020-1CLG484

Memory: 1GByte (32Mword x 32bit x 8banks) DDR3 SDRAM Component

128Mbit Quad SPI Flash

Secure Digital Card (Connector)

Ethernet PHY: Marvell’s 88E1518-XX-NNB2C000 RGMII Interface with RJ45

USB OTG 2.0 Transceiver: TI’s TUSB1210BRHB *1

DVI Complaint Transmitter: TI’s TFP410PAP

RS232 Transceiver: TI’s MAX3232CPW with 2.0 pitch PinHeader*2

FMC Connector: Samtec’s ASP-134604-01 (FMC LPC MC) mounted on bottom side*3

Samtec’s ASP-134603-01 (FMC LPC CC) mounted on top side*3

Cation: FMC connetors are only exclusice use

CAN Bus Transceiver: PHILIPS’s TXS0104EPWR with 2.0 pitch PinHeader*2

Pmod Connector: Digilent Pmod™ compatible headers (2x6)

JTAG Port: Standard Xilinx JTAG Interface with 14-pin 2.0 pitch PinHeader

ARM JTAG + Logic Analyzer function Interface with Mictor-38 Connector

SD Card: microSD Card connector

Oscillators: Fixed 33.33333MHz LVCMOS oscillator

Clock Generator: IDT’s 5V49EE504NLGI

Note *1: TUSB1210 and Zynq-7000 have a timing incompatibility at hot temperature.

Please use TB-7Z-020-EMC at room temperature.

Note *2: Rs-232C and CAN interfaces are connecting by accessory cable.

Note *3: FMC connetors are only exclusice use.