User manual

TB-7Z-020-EMC Hardware User Manual
21
Rev.1.03
7.5.2. QSPI Flash
The Board includes a 4-bit QSPI (quad-SPI) 128Mbit NOR flash. The Micron N25Q128A13BSF40F is
used on this board. The Multi-I/O SPI Flash memory is used to provide non-volatile code, and data
storage. It can be used to initialize the PS as well as configure the PL (bitstream).
Device: N25Q128A13BSF40F (Micron) 128Mbit , x1/x2/x4 support (or compatible device)
Device Data Rate: 108 MHz (maximum) clock frequency
The QSPI interface is shown in Figure 7-9.
CLK , XCS
DQ[3:0]
ZYNQ
XC7Z020-1CLG484
PS Bank500
QSPI Flash
128Mbit
N25Q128A13
BSF40F
(U13)
Figure 7-9 QSPI Connection
7.5.3. SD Card Interface
The Zynq AP SoC PS SD/SDIO peripheral controls communication with the SD card. The SD card can
be used for non-volatile external memory storage as well as booting the Zynq AP SoC.
Device Features: microSD Card Slot ST1W 008S4ER1500 (JAE Electronics)
Media is 4GB uSD card support
The microSD Card interface is shown in Figure 7-10.
CLK , CMD
DAT[3:0]
CLK , CMD
DAT[3:0]
ZYNQ
XC7Z020-1CLG484
PS Bank501
SDIO Level
Translator
TXS02612RTWR
(U14)
microSD Card
Slot
ST1W 008S4
ER1500
(CN11)
Figure 7-10 SD Card Slot Connection
Figure 7-11 micro SD CARD Socket
Slide
Un-lock
Insert
Close and
lock
Open