Specifications

ManualsBrandsEpson ManualsComputer equipmentPowerspan

EPSON PowerSpan DT

Cache memory

hard disk

diskette

drive

power

drive

release

aocess

light light

access

light button

Mankfller

power

pSIl&

button

ROM

voltage

selector

switch

expansion

AC output

card slots

socket

KEYtiD

&,,

power

AC input

MOUSE

COM2

LPT

supply

fan

socket

Computer Specifications

CPU and Memory

CPU

Intel Pentium 60 MHz microprocessor;

backward compatible with 8086, 80286,

i386,

and

486

CPUs; supports read and

write burst mode bus cycles; built-in 16KB

write-back

cache;

integrated math

coprocessor

System speed

System memory

High and low speeds available; high speed

is 60 MHz and low speed is simulated

8 MHz for compatibility; speed selection

through Setup program or keyboard

commands

8MB standard memory on two 4MB

SIMMs; expandable to 128MB using 1 MB,

2MB, 4MB, 8MB, 16MB, and 32MB SIMMs

(when readily available); SIMMs must be

32-bit or 36-bit, 72-pin, 70ns or faster,

tin-plated, fast-page mode, parity/no

parity type

Video RAM

Shadow RAM

Clock/

calendar

Controllers

Video

Diskette

Hard disk

Built-m 16KB of internal write-back cache

in the Pentium microprocessor; 256KB of

secondary, direct-mapped, write-through

cache on eight 32KB

8,15ns

SRAMs

the main system board; tag and control

logic on the 82434LX PCMC core chip

128KB system and video BIOS located on

a flash EEPROM device; contains Setup

program code, power-on self test code,

update recovery code, and the

PC1

board

auto-configuration utility; upgradable and

write-protectable

1MB of standard video RAM providing

video resolutions up to 1024

768 in

256 colors; expandable to 2MB by

installing eight 256KB

4, 60ns ZIP

VRAMs on the main system board to

provide resolutions up to 1280

1024 in

256

colors

Supports shadowing of system and video

BIOS ROM, and ROM located on

expansion board adapters, into RAM

Real-time clock, calendar, and 128-byte

CMOS RAM (114 bytes for general

purpose non-volatile CMOS RAM and

14 bytes for clock and control registers)

socketed DS12887 device; integrated

battery and oscillator; CMOS RAM

clearable and resettable using the Setup

program or by setting a main system

board jumper

ATI 68800AX Mach32 local bus PCI

graphics accelerator; compatible with

MDA, CGA, Hercules Graphics, EGA, and

VGA video standards; supports normal

and enhanced video modes; supports

interlaced and non-interlaced monitors

SMC FDC37C665 super I/O controller

with interface on the main system board

controls up to two diskette drives or one

diskette drive and one tape drive; 16-byte

data FIFO (first-in-first-out) with 2.88MB

diskette drive support

SMC FDC37C665 super I/O controller

with interface on the main system board

controls up to two IDE hard disk drives;

BIOS provides hard disk auto-sensing

function

3/94

EPSON PowerSpan DT - 1

Summary of content (11 pages)

PAGE 1
EPSON PowerSpan DT hard disk diskette diskette drive power drive release aocess light light access light button AC output socket \ / power supply fan Built-m 16KB of internal write-back cache in the Pentium microprocessor; 256KB of secondary, direct-mapped, write-through cache on eight 32KB x 8,15ns SRAMs on the main system board; tag and control logic on the 82434LX PCMC core chip ROM 128KB system and video BIOS located on a flash EEPROM device; contains Setup program code, power-on self test code, u
PAGE 2
EPSON PowerSpan DT Parallel port Serial ports SMC FDC37C665 super I/O controller provides multiple modes: standard (IBM and Centronics compatible), enhanced (EPP with bidirectional functions and BIOS/driver support), and high speed (ECP compatible) Physical Characteristics Dimension Width Depth Height Weight SMC FDC37C665 super I/O controller supports two RS-232C compatible serial ports Power Supply Interfaces Video SVGA PCI local bus interface with standard, 15-pin analog connector; VESA compliant 8
PAGE 3
EPSON PowerSpan DT Main System Board Map VGA port parallel port WM2 sertai port COMl serial port mouse pofi keyboard port jumper J13H3 Mach32 sraphi= controller jumper J13Hl \ VFW4 expansion jumperJl2Hi prtmary power - connector sockets \ -- real-time dock VESA connector auxiliary 3.
PAGE 4
EPSON PowerSpan DT System board components and connectors SIMM lnstallation Your computer comes with 8MB of memory on two 4MB SIMMs. You can increase the memory up to 128MB using 1MB, 2MB, 4MB, 8MB, 16MB, and 32MB SIMMs (when readily available). Jl3Gl Jl3Hl 1 J13Hl Jl3H3 Jl3H3 J13H5 JIDAI JIFI JlF2 JlF3 JIG1 JIG2 JlHl J3Al J4F1, J4Gl J4H1, J4H2 J7Al J7Hl J6Jl J6J2 J9Fl Jgfil UiOB5, UIOCI UloGl UlaJl U2Bl The SIMM sockets are organized in two banks (Bank 0 and Bank 1) consisting of two sockets each.
PAGE 5
EPSON PowerSpan DT The table below lists the monitors that are directly supported by the Mach32 accelerator. Video Memory, Modes, and Monitors Check the monitor documentation to see if its characteristics match one of the listed types. If so, select that type in the Mach32 installation program. This system comes with 1MB of VRAM soldered on the main system board. You can increase the video memory to 2MB by installing eight VRAM ZIP chips (256KB x 4, 60ns, fast-page mode). You must fill all eight sockets.
PAGE 6
EPSON PowerSpan DT System Memory Map Drive Option Information Hard disk drive options for 1-inch IDE drives Quantum Western Digital flq$ i &39& I.? 0 z Y g 340 Connor Parameters 4 4 Formattedcapacity 250 WV Size, width x height 4 x 1 (in) Weight (Ibs) 11.2 340 426.3 540 245 240 4x1 4x1 4x1 4x1 3.5x1 3 . 5 x 1.16 Il.16 Il.05 Cylinders DiSkS 8 11.2 1695 2116 2366 2605 12 1 2 12 12 4 I II.
PAGE 7
EPSON PowerSpan DT System I/O addresses (continued) Serial port connector pin assignments (113El,]l3Fl) I Address range 1 (hexadecimal) Description C000-COFF 82434LX contiguratton registers C2OO-C2FF C3OO-C3FF Pin 1 12 13 4 5 8237818 configuratton registers Onboard ATI contlguration registers System Board Interrupts 1 Signal name 1 Pin I Signal name Incn 1 DSR ISWWItlIFITS 1 Serial Out- II 17 18 IQ 1 10 I r-!-l-c jDTF7 1 RI 1 GtiD 1 NC 1 Primary power connector pin assignments (JllHl) Auxili
PAGE 8
EPSON PowerSpan DT AT IDE hard disk drive connector pin assignments (1812) Pin 1 3 Signal name Reset IDE Host Data 7 Pin 2 4 ISA expansion board connector pin assignments (continued) Pin 825 B26 027 820 829 830 831 KEY Signal name Ground Host Data 8 1 Slgnal name 1 IRQ3 IIBin IA25 1 Signal name ISA6 ITC IA27 ISA4 IBALE IA28 ISA3 vcc osc GND A29 A30 A31 KEY sA2 SAl SAO I I Stmker connector pin asshments trlF1) Pin 1 1 Signal name 1 SPKR-DAT 3 4 No Connect +!iu us-x? PC1 expansion board
PAGE 9
EPSON PowerSpan DT VESA feature connector pin assignments (JlOAl) (continued) PCI expansion board connector pin assignments (continued) Signal S4Ml S@d s4w Pin name Pin A29 AD20 A30 GND A 3 1 AD16 829 AD21 830 AD19 831 3.
PAGE 10
EPSON PowerSpan DT Error messages (continued) Tested Operating Environments Although the system will run most software applications, the following operating environments have been tested for compatibility with this system. Microsoft MS-DOS Novell DR DOS 6.0 Novell NetWare 2.2,3.12, and 4.01 Novell NetWare Lite 1.1 IBM OS/2 2.1 SC0 UNIX release 3.2, version 4.2 SC0 Open Desktop 3.0 Microsoft Windows 3.0 and 3.1 Microsoft Windows for WorkGroups 3.11 Microsoft Windows NT 3.1 NextStep version 3.
PAGE 11
EPSON PowerSpan DT Keyboard and Monitor Even if you intend to use this system as a network file server, you need to connect a monitor and a keyboard to complete the installation. You may remove them once the installation is complete. Mouse and Keyboard When connecting the mouse and keyboard, be careful to plug them into the proper ports. Although they are physically identical, they are not interchangeable, and damage may occur to the ports or the main system board.