EPSON ACTIONSCANNER II Document cover Storage hole Parallel port Transportation screw DIP switch AC inlet Document glass (platen) Carriage (at home position) Storage hole Transportation screw Terminator DIP switch AC inlet OPERATE button OPERATE light RESET button ERROR light READY light SCSI interface connectors Color byte sequence mode: Three-pass scanning (R, G, B) Color line sequence mode: One-pass scanning (R, G, B) Scanner Specifications Scanner type: Flatbed, color/monochrome Photoe
EPSON ACTIONSCANNER II Color correction: 1 type for CRT display 3 types for printer output, available in color line sequence mode only 1 type for user-defined Interface: Bidirectional parallel or SCSI Light source: Noble gas fluorescent lamps Input frequency: 49.5 to 60.5 Hz Power consumption: Approx. 18W (self testing) Safety, EMI, and EMS 100120 V model Safety: UL1950 (+D3) CSA 22.2 No.
EPSON ACTIONSCANNER II Signal pin assignments Parallel Interface Specifications Interface type: Bidirectional parallel Pin Return No. Pin Signal Direction Function 1 19 STROBE IN STROBE pulse to read in or send out data. Pulse width must be more than Data format: 0.5 microseconds at the receiving 8-bit parallel terminal.
EPSON ACTIONSCANNER II Signal pin assignments SCSI Specifications The direction of signals is as viewed from the scanner. Interface type: ANSI X3.131-1986 standard Signal Function: GND The following functions are included. BUS FREE phase ARBITRATION phase SELECTION/RESELECTION phase COMMAND phase (Logical Unit Number is fixed to 0 and command link function is not supported.
EPSON ACTIONSCANNER II When this error occurs, try to rescan the document. The scanner returns to normal when it receives correct commands. Normally you do not need to reset the scanner. Lights and Buttons The scanner has three indicator lights and two buttons. Interface Error E RR O R l ig h t O PE RA TE b u t to n The interface setup is wrong, or the scanner is not properly connected to the computer. When this error occurs, check the interface connection.
EPSON ACTIONSCANNER II Be careful not to spill liquid into the scanner mechanism or electronic components. This could permanently damage the mechanism and circuitry. Do not spray lubricants inside the scanner. Never open the scanner case. Replacing the Fluorescent Lamps The luminosity of the fluorescent lamps declines over time. If the lamps break or become too dim to operate normally, the scanner stops working and both the READY light and the ERROR light flash.