OWNERʼS MANUAL BASS LOUDSPEAKERS
Important Safety Information 1. 2. 3. 4. 5. 6. 7. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any ventilation openings. Install in accordance with all applicable manufacturer's instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
SPEAKER CONTROL PANEL 1. Tweeter Level – Three-way switch attenuates the output level of the tweeter. Set to HI for maximum volume, NORM for moderate volume or OFF to disable the tweeter. 2. Speaker Input/Output – ¼” TS Phone jacks wired in parallel. Use only unshielded 16gauge or lower speaker cable to connect your amplifierʼs speaker output to either jack. Use the other jack to daisy-chain an additional cabinet. Take care not to exceed the minimum impedance of the amplifier.
SPECIFICATIONS EpiFunky 410 CONFIGURATION IMPEDANCE OPTIMUM POWER RATING FREQUENCY RESPONSE SENSITIVITY HARDWARE DIMENSIONS WEIGHT EpiFunky 210 CONFIGURATION IMPEDANCE OPTIMUM POWER RATING FREQUENCY RESPONSE SENSITIVITY HARDWARE DIMENSIONS WEIGHT EpiFunky 115 CONFIGURATION IMPEDANCE OPTIMUM POWER RATING FREQUENCY RESPONSE SENSITIVITY HARDWARE DIMENSIONS WEIGHT 4 x 10" 125-watt Epifani ceramic drivers 1" compression tweeter with three-way switch 4Ω 500-watts RMS 39Hz - 16kHz 102dB (1W@1m) 2x 1/4" output