Installation Instructions

9-Bottle Modern Peg Wine Rack Installation Instructions
EP-WALLRACK9B
Diagram A: Mounting Dimensions Diagram B: Installation
1. Deciding Where the Racks Will Go
Please allow 3-1/4” between the Left and Right rack
supports. If multiple rack sets are being used
side-by-side, allow at least 8” between rack sets.
Please check your bottle height to verify that this will
be acceptable to you. (See Diagram “A” below)
2. Mounting the Racks
Mounting is done by placing 3 screws in each of the
three holes located on each rack support. If possible
place over studs in the wall. If this is not possible, you
will need to purchase wall anchors.
(See Diagram “B” below)
Note: When racks are full of bottles they will weigh
approximately 100 lbs.
8” Minimum
needed between
multiple racks
Please check your
bottles to verify
what this dimension
should be.
3-1/4”
Installation Instructions
17621 S. Susana Rd., Rancho Dominguez CA 90221 U.S.A.
800.777.8466 | [e-mail] | www.epicureanist.com