Eon unit is easy to install. You will enjoy installing it by yourself to save time, effort and the huge amount of installation fee.
Contents Disassembly steps Chevrolet Avalanche, Silverware) GMC Denali, Yukon, Sierra(a) Chevrolet Overaggressive) GMC Sierra(B) Chevrolet Impala Chevrolet Traverse GMC Acadia Buick Enclave Chevrolet Express GMC Havana Disassembly steps WISING GENOA correctness sermons 54
Hexagon screwdriver I A (o]) \ = Use a hexagon screwdriver to remove the bolts on the factory CD player and AC control panel.
Hexagon screwdriver = ® Use a hexagon screwdriver to remove the bolts on the panel that under the steering wheel.
Pry it until you can see the gap. Take out the silver trim strip from the gap. Pry the glove box panel of co-pilot position from edge with the plastic tool first.
Pry it with the plastic tool. @ — Take out the trim panel around the gear sifter. hi O Pry the trim panel around the gear sifter from edge with plastic tool first.
Use a screwdriver to remove the 2 bolts on the panel under the steering wheel, and take the panel out.
Unplug all cables and take out the trim panel{please do not disconnect the airbag light interface).
0 Take out the Eon head unit from the packing box. Use Phillips screwdriver to remove 2 screws on the top of head unit, which are used to fix the DVD-ROM inside.
Connect the head unit to the car radio plug via Eon radio harness. (please connect the CAN Bus to the power cable first if your head unit is equipped one.
Radio antenna amplifier used to improve the radio sigma} (om) [© moo Radio antenna adapter cable Factory radio Connect the radio antenna adapter cable to the the factory radio antenna connector (If the factory radio harness needs power supply, then please connect the blue wire of the radio antenna power cable with the blue wire of the signal booster.
Test all features of the head unit(FM, DVD, SD, USB, Bluetooth, reversing, handbrake, headlight, steering wheel control) before going to next step.
Open the glove box, and pull the USB plug from the center console to the glove box through the gap between them.
Release the weatherstrip on A pillar to install GPS antenna, microphone etc. (Note: The A pillar is near the driver seat.
Place the microphone here. Stick the dash cam on the windshield. Clip the microphone wherever you want and get the best voice reception.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam wire into the A pillar, and then reinstall A pillar trim.
Microphone GPS antenna Place the GPS antenna and microphone as shown. The wires should be led to the head unit through A pillar and the trim behind the steering wheel.
pon aaa! Pull the microphone wire, GPS antenna, WiFi antenna, dash cam USB wire, reversing rear view wire to the center console.