Eon unit is easy to install. You will enjoy installing it by yourself to save time, effort and the huge amount of installation fee.
Automatic air conditioning COO Op fre 22 CTY | © J Confirm the size and shape of the center console panel.
\ Manual air conditioning J 14cm tlc 22cm COO Op OHO J | Confirm the size and shape of the center console panel.
OTT opm For the car with switch panel shown in Figure 1, relocation kit (figure 2) is required for installation as shown in figure kit is not included in the package) ga
C0 CJ Power cord Radio antenna Release the plugs and the antenna of the head unit.
Allen wrench CD Il Use a Allen wrench to remove the 2 fixed | screws on the factory mounting bracket. Use a T20 Tory screwdriver to ® remove the 4 fixed screws on the factory mounting bracket.
Take out the Eon head unit from the packing box. Use Phillips screwdriver to remove 2 screws on the top of head unit, which are used to fix the DVD Rom inside.
Factory radio harness Connect the radio antenna connector with the factory radio harness.
Test all features of the head unit(FM, DVD, SD, USB, Bluetooth, GPS, reversing, handbrake, headlight, steering wheel controls) before going to next step.
When putting the head unit into the central console, please pay attention to place the snap clip into the mounting bracket and lock it.
» Connect the power cord of factory air conditioning controller and install on the center console.
= : Mrz When putting the air conditioning controller into the center console, please pay attention to place the snap clip into the mounting bracket and lock it.
USB port / STR Open the glove box, pull the USB plug from the center console to the glove box through the gap between them.
Release the weatherstrip on A pillar to install GPS antenna, microphone etc. (Note: The A pillar is near the driver seat.
Place the microphone here. Stick the dash cam on the windshield. Clip the microphone wherever you want and get the best voice reception.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam wire into the A pillar. And then reinstall A pillar trim.
Microphone = Place the GPS antenna and microphone as shown. The wires should be led to the head unit through A pillar and the trim behind the steering wheel.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam USB wire, reversing rear view wire to the center console.