Eon unit is easy to install. You will enjoy installing it by yourself to save time, effort and the huge amount of installation fee.
Use a Phillips screwdriver to remove the 2 fixed screws on the factory CD player.
Take out the Eon head unit from the packing box. Use Phillips screwdriver to remove 2 screws on the top of head unit, which are used to fix the DVD-ROM inside.
ANT Connect the radio antenna connector with the factory radio the factory radio harness needs power supply, then please connect the blue wire of the radio antenna power cable with the blue wire of the signal booster.
= Test all features of the head unit(FM, DVD, SD, USB, Bluetooth, reversing, handbrake, headlight, steering wheel control) before going to next step.
Open the glove box, and pull the USB plug from the center console to the glove box through the gap between them.
g i» 7 Release the weatherstrip on A pillar to install GPS antenna, microphone etc. (Note: The A pillar is near the driver seat.
Stick the dash cam on the windshield. Clip the microphone wherever you want and get the best voice reception.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam wire into the A pillar, and then reinstall A pillar trim.
Place the GPS antenna and microphone as shown. The wires /) should be led to the head unit through A pillar and the trim behind the steering wheel.
Pull the microphone wire, GPS antenna, WiFi antenna, dash cam USB wire, reversing rear view wire to the center console.