User Guide

正面
User’s Guide
Eono Headphone 1
If the operation mode of the product has been changed, please refer to the actual product
Li-ion polymer battery
Model:
Rating:
3.7V, 1.48Wh 400mAh
-
+
(IICR19/66)
Made in China
WARNING:
CAUTION:Risk of explosion if the battery is replaced an incorrect
disposal of a battery into fire or a hot oven, or mechanically
crushing or cutting of a battery, that can result in an explosion;
leaving a battery in an extremely high temperature surrounding
environment that can result in an explosion or the leakage of
flammable liquid or gas;battery subjected to extremely low air
pressure that may result in an explosion or the leakage of
flammable liquid or gas.
902025PL
RED BLK
-Fully dry off the USB port before charging.
-Use a certified USB-C charging cable and charger to prevent any
damage.
*Do not power on your headphone while charging
Charging
Press and hold the power button for 3 seconds to power on/off.
Powering On/Off
When successfully connected with the first device,press twice the
power button to pair up with another devive.
Pairing with another device
To reduce ambient noise,turn on the active noise cancellation mode by
pressing the NC button.Press the NCbutton again to turn off.
Noise Cancellation Mode
Play audio on an external device by plugging in a 3.5mm AUX cable.
*When the headphone is out of battery,you can still listen to music but
ANC mode is unavailable.
AUX Mode
Specifications are subject to change without notice
Product parameters
You might need to reset your headphone if you experience any
connectivity problems or function issues.
Press and hold the power button and volume up button simultaneously
for 5 seconds until the LED indcator flashes blue and red alternately twice.
Reset
To stay aware of your surroundings by allowing ambient sounds in,touch
the right panel for 1 second to activate the transparenc mode.
Transparency Mode
Button Controls
1. When powered off, press and hold the power button for 5 seconds
until the LED flashes blue to enther the Bluetooth pairing mode.
2. Select “Soundcore S3”on your device’s Bluetooth list to connect.
Bluetooth Pairing
Flashing red once every 60 seconds
Steady red Being charged
Fully charged
Low battery
Flashing blue
Steady blue Bluetooth connected
Bluetooth pairing
Light off
L
R
ON
OFF
3s
L
R
5s
1
5s
S3
L
R
L
R
x2
x1
L
R
-Your Soundcore headphone can only play music on one mobile device at a
time.To play from another connected device,pause the device that’s currently
active first
-Each time you power on your Soundcore headphone,it will automatically
connect to your last successfully connected device if available within the
Blutooth range.
S3
L
L
L
L
L
R
R
R
R
R
Play/Pause
Press
Press and hold for 1 second
Press and hold for 1 second
Press
Press
Press and hold for
1 second
Press and hold for
1 second
Next track
Previous track
Volume up/down
Answer/End a call
Put the current call on hold and answer a
new incoming call
Reject a call
Switch between held call and active call
Activate Siri or other voice assistant
software
1S
3 mm5.
5V 0.5A
1.5H
10H
15H
40 mm X 2
20 Hz-20 kHz (Bluetooth)
16Hz-40kHz(AUX)
16Q
V5.0
15 m
5s
x2
Input
Charging time
Play time ( with ANC mode turn on)
Play time ( with ANC mode turn off)
Driver size
Impedance
Bluetooth version
Bluetooth Range
Frequency Range