Installation & Operation Manual EMS Wireless Multi-Sensor
Introduction The EMS provides three (3) wireless zones in one device to use with your SOLO wireless security system. The EMS has one integral door/window magnet contact sensor, and support for up to two additional external sensors. The EMS sensor has terminal connections that allow for up to two additional external sensors to be connected, such as a water/flood sensor, a hardwired door/window contact or an external temperature sensor. The EMS also includes two tamper switches for your added security.
Installation 1. Select the location where the EMS is to be mounted. RF signals can be interrupted by metal objects, including metal doors or large mirrors. Ensure that these types of objects are not in the way as it can interfere with the proper operation of the EMS sensor. 2. Place the mounting bracket in the position you have selected. Secure the bracket by using the two screws or adhesive tape provided. 1. Screws to hold bracket 2. Mounting bracket 3. Tab to release door sensor 4. Adhesive tape 3.
Zone 1 Zone 2 Zone 3 12345A 12345A:2 12345A:3 Operation The EMS will transmit when any of the three zones are either opened or closed. When transmitting, the LED on the front cover of the EMS will illuminate briefly. In addition to tamper protection, the EMS is fully supervised with the SOLO base-station. It also monitors the battery and will notify the SOLO base-station if the battery needs to be replaced.
units not used in accordance with instruction; (4) damages exceeding the cost of the product; (5) transit damage, initial installation costs, removal cost, or reinstallation cost.