Installation & Operation Manual

Federal Communications Commission Statement

This equipment has been followed to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used

in accordance with the instruction, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try and correct the interference by one of the following measures:

Reorient or relocate the receiving antenna,

Increase the separation between the equipment and receiver,

Connect the equipment into and outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equipment.

Limited Warranty

Envisacor guarantees that every wireless siren & strobe alarm is free from physical defects in

material and workmanship under normal usage for one year from the date of installation. If the

product proves defective during this one-year warranty period, Envisacor will replace it free of

charge. This warranty is extended to the original end user purchase only and is not

transferable. This warranty does not apply to : (1) damage to units caused by accident,

dropping or abuse in handling, or any negligent usage; (2) units which have been repaired,

taken apart, or modified by a unauthorized personnel;

(3) units not used in accordance with instruction; (4) damages exceeding the cost of the

product; (5) transit damage, initial installation costs, removal cost, or reinstallation cost.

HM1601

1091103

6B1H-16UC

Installation & Operation Manual

HM1601

Wireless Siren

PAGE 1
Federal Communications Commission Statement This equipment has been followed to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.
PAGE 2
-3-
PAGE 3
4. Introduction Thanks for choosing the HM1601 wireless siren and strobe for the SOLO wireless security system. This device extends the audio and visual alarm notifications of the SOLO base station to anywhere in your home. You can add up to four (4) HM1601s to a single SOLO base station. The HM1601 provides separate visual and audio notifications for burglary, fire, waterflow, and personal medical alarms. The HM1601 is fully supervised and includes low-battery notifications, wirelessly. 5. 6. 7.