User's Manual

ManualsBrandsENUSTECH ManualsElectronicsWIRELESS HANDSFREE CARKIT

1. Before using your Hands-Free BHF-300

1) Display LED : Power ON(LED1), Link status(LED2), Call Connection status(LED3),

Battery status(LED4)

2) Internal Microphone

3) Volume-UP button

4) Volume-Down button

5) Multi-function button : Power ON/OFF, Send call, End call

6) External charger connector

7) Internal Speaker

2. Charging Your Hands-Free

Use the vehicle power charger provided.

BHF-300 uses a rechargeable battery that must be fully charged before you use it

For the first time.

Connect the supplied vehicle power charger to power socket and then to your

Hands-Free. The status of indicator on Vehicle charger will be illuminated red

while charging and change to Green when the Hands-Free is fully charged.

It takes approximately 2 hours to fully charge the Hands-free

Summary of content (4 pages)

PAGE 1
. Before using your Hands-Free BHF-300 1 2 5 4 3 6 7 1) Display LED : Power ON(LED1), Link status(LED2), Call Connection status(LED3), Battery status(LED4) 2) Internal Microphone 3) Volume-UP button 4) Volume-Down button 5) Multi-function button : Power ON/OFF, Send call, End call 6) External charger connector 7) Internal Speaker 2. Charging Your Hands-Free Use the vehicle power charger provided. BHF-300 uses a rechargeable battery that must be fully charged before you use it For the first time.
PAGE 2
NOTICE: If battery is Low(1~2 hours Talk time) , Red light of the LED4 will blink in every five seconds. If battery is Very Low(0~1 hours Talk time), Red light of the LED4 will blink in every second. 3. BLUETOOTH PAIRING Before using your hands-free for the first time with a mobile phone or another Bluetooth device, you must first pair it with the device. Follow the steps below for most devices. You can also refer your phone user guide. 1) Turn off the Hands-free, if Hands-free turned on.
PAGE 3
Press the multifunction buttons for four seconds in order to turn off the device. 2) Connect the Hands-free to the phone When disconnected, the Hands-free can be re-connected to the phone by simply short pressing the Multi-function button. 3) Answer / End / Place a call To answer a call, short press the Multi-function button. To end a call, short press the Multi-function button.
PAGE 4
User’s Information Cautions Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance Information This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received. Including interference that may cause undesired operation.