User's Manual

ManualsBrandsENUSTECH ManualsElectronicsWIRELESS HANDSFREE CARKIT

1. Before using your Hands-Free BHF-200

Status Indicators

1) Power LED – Power on mode

2) LED 1 -> Connecting Status

Stand by Mode : two times blinking every two second

Pairing Mode : blinking continuously.

Active Mode : Power on continuously

3) LED 2 -> Call Activity Status

Sending and Receiving Phone Call : Blinking shortly

Using Hands Free : Power on continuously

4) LED 3 -> ( Low battery Status ) : LED blinking continuously

2. Charging Your Hands-Free

Use the vehicle power charger provided.

Summary of content (4 pages)

PAGE 1
. Before using your Hands-Free BHF-200 Status Indicators 1) Power LED – Power on mode 2) LED 1 -> Connecting Status Stand by Mode : two times blinking every two second Pairing Mode : blinking continuously. Active Mode 3) LED 2 : Power on continuously -> Call Activity Status Sending and Receiving Phone Call : Blinking shortly Using Hands Free : Power on continuously 4) LED 3 -> ( Low battery Status ) : LED blinking continuously 2. Charging Your Hands-Free Use the vehicle power charger provided.
PAGE 2
BHF-200 uses a rechargeable battery that must be fully charged before you use it For the first time. Connect the supplied vehicle power charger to power socket and then to your Hands-Free. The status of indicator on Vehicle charger will be illuminated red while charging and change to Green when the Hands-Free is fully charged. It takes approximately 2 hours to fully charge the Hands-free NOTICE: If battery is Low, Blue light of the LED 3 will blink in every second. 3.
PAGE 3
4. USING YOUR HANDS-FREE 1) Power On / Off Press the multifunction buttons for two seconds in order to turn of the device. Press the multifunction buttons for five seconds in order to turn off the device. 2) Connect the Hands-free to the phone When disconnected, the Hands-free can be re-connected to the phone by simply short pressing the multifunction button.
PAGE 4
Additional page Regulatory Information FCC compliance Information This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received. Including interference that may cause undesired operation. Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to part 15 of the FCC Rules.