User's Manual

Instructions: 79613879
Datacard RFID MODULE 506241 INSTRUCTIONS
1. The 506241 module is powered by 5.0 vdc limited power circuit.
2. It is recommended that a NSP Semiconductor series CLRC66 controller be used
to monitor the 506241 RFID module
3. The 506241 module must be mounted in the Datacard device in a vertical position
with the antenna down, as shown below.
4. The 506241 module is to be installed in the Datacard device no more than 10 CM
from the supply roll containing the RFID tag.