Ib Your Wireless Keypad will also work with a remote transmitter. For purchase of a remote transmitter or additional accessories, visit www. directwholesale.net or call 800-659-0764. springiness gE Naa FOR TECHNICAL ASSISTANCE www.bulldogsecurity.com email: 1-800-878-8007 FOR TECHNICAL ASSISTANCE www.bulldogsecurity.
NOTES 18 CONTENTS System System Components Technical Precautions. 4 4 4 Before You Begin 5 5 7 Making Wiring Connections 6 Locating & Making Locating & Determining Yc Your Door Lock Types... SR. Testing Door Locks Connecting Door Locks 14-Pin Ha mess Diagram 12 Door Lock Type by Programming Your Receiver Programming Instructions .. Using Your Wireless Keypad Mounting Your Wireless 17 FCC ID .17 Notes .
SYSTEM FEATURES Five-Bunion Re mutely lock and unlock your vehicles from the outside Wireless Keypad Starter You can't steal what you can't start Immobilizer Most insurance companies offer a discount for this feature. {Optional Part #773 Required) Trunk Release Ceremonially opens your trunk. (Optional part #775 required.) Parking Light Confirms that your vehicles has received a remote Confirmation signal and remains on for tan seconds when disarming.
RECEIVER PROGRAMMING INSTRUCTIONS Cont, Adding additional remotes with a working keypad Enter the 5-Dwight Primary Code. Press and hood Buttons 7/8 and 9/0 at the samey time on the for 20 seconds, release. Next, press and hold Button #1 (Lock) on the new remote for 20 seconds, then release Button #1 (Lock), try new remote. Adding additional remotes without a working keypad Unplug the main unit from under the dash, wait one minute. Plug the unit back in and use the new remote control.
MAKING WIRING CONNECTIONS 1. Strip back two Inches of Insulation on the wire from the key loss entry. Two Inches of Bare Wire 2. Strip back one Inch of Insulation on the wire you need to connect to. One Inch of Bars Wire — CC Tewescsswsea 3. Separate tho vehicle wire as shown. Make the separation large enough to fit the other wire through. CC fy) 4. Insert the wire from the unit through the hole as shown. 5. Wrap the wire around one side then the other and finally around itself as shown. 8.