User's Manual

ManualsBrandsEnterprise Electronics ManualsElectronicsKeypad Transmitter

Table Of Contents

KEYLESS ENTRY SYSTEM

Locks and Security

KEYLESS ENTRY SYSTEM

If there is any potential keyless entry problem with your vehicle,

ensure ALL key fobs (remote entry transmitters) are brought to the

dealership, to aid in troubleshooting.

Your vehicle is equipped with a keyless entry keypad, you can:

• lock or unlock the vehicle doors without using the key.

Your vehicle has a factory-set 5 digit code that operates the keyless

entry system. You can also program your own 5 digit personal

entry code. The factory-set code is located:

• on the owner’s wallet card in the glove compartment

• or at your dealer.

When pressing the controls on the keyless entry keypad, press the

middle of the controls to ensure a good activation.

Programming your own personal entry code

To program your own code:

1. Enter factory set code.

1 - 2 3 - 4 5 - 6 7 - 8 9 - 0

2. Press 1/2 control within five

seconds of step 1.

3. Enter your personal 5 digit code. Enter each digit within five

seconds of previous one.

Do not set a code that includes five of the same number or presents

them in sequential order. Thieves can easily figure out these types

of codes.

Your personal code does not replace the permanent code that the

dealership gave you. You can use either code to unlock your

Summary of content (6 pages)

PAGE 1
Locks and Security KEYLESS ENTRY SYSTEM If there is any potential keyless entry problem with your vehicle, ensure ALL key fobs (remote entry transmitters) are brought to the dealership, to aid in troubleshooting. Your vehicle is equipped with a keyless entry keypad, you can: • lock or unlock the vehicle doors without using the key. Your vehicle has a factory-set 5 digit code that operates the keyless entry system. You can also program your own 5 digit personal entry code.
PAGE 2
Locks and Security vehicle. If a second personal code is entered, the module will erase it in favor of the new code. If you wish to erase your personal code, use the following instructions: 1. Enter factory set code. 2. Press 1/2 control within five seconds of step one. 3. Press 7/8 control and 9/0 control at the same time within five seconds of step 2. 1-2 3-4 5-6 7-8 9-0 The system will now only respond to the factory set code.
PAGE 3
Locks and Security Unlocking the doors with the keyless entry system To unlock the driver door, enter either the factory set code or the personal code (each digit must be pressed within five seconds of the prior digit). 1-2 3-4 5-6 7-8 9-0 To unlock all doors, enter the factory set code or personal code (driver door unlocks) and press the 3/4 control within five seconds.
PAGE 4
Locks and Security To replace the batteries: 1. Take a regular flat head screwdriver with a ¼” wide head and insert it into the slot on the right side of the keypad. Gently twist the screwdriver to pry off the top cover. Pull cover off by pulling to the left and then up. The top cover and the guts of the keypad will come off the vehicle and the back cover will remain mounted to the vehicle. 2.
PAGE 5
Locks and Security Replacement of the battery will not cause the keypad to become deprogrammed from your vehicle. The keypad should operate normally after battery replacement.
PAGE 6
Locks and Security before pressing a remote transmitter button, the programming mode will exit and the procedure will have to be repeated). • Within 20 seconds, program the remote transmitter by pressing any button on a transmitter. The doors will lock/unlock to confirm that the remote transmitter has been programmed. • Repeat the previous step to program additional remote transmitters. The doors will lock/unlock to confirm that each remote transmitter has been programmed.