User manual

Copyright Entel UK 2008
FEATURES
OPERATING INSTRUCTIONS
Thank you for purchasing the CSBHX charger.
This product should reach you in perfect condition.
Should you notice any defects or experience any
problems with this product, please contact the
dealer from whom you purchased it immediately.
The CSBHX charger provides rapid recharging
of Lithium-Ion battery packs for the Entel HX400
series transceivers.
Free-range power supply facilitates both 100v
and 240v AC outlets.
The HX400 series battery pack can be charged in
the front slot of the dual-slot CSBHX charger
while still attached to your HX400 transceiver, or,
alternatively, on its own in the rear slot. Two
battery packs may be inserted into the front and
rear slots simultaneously, but the battery pack in
the rear slot will only begin charging once the
battery pack in the front slot has completed its
charge cycle.
The time required to charge a fully discharged
battery pack is 2 hours, 30mins.
When rapid charge is complete, the CSBHX
automatically switches to standby.
This charger has been designed to sit on a
desktop, or to be wall mounted.
1. Plug the AC power cord of the charger into a
wall outlet.
2. Switch the transceiver off.
3. Insert the battery pack into the CSBHX, either
with or without the transceiver attached.
The LED illuminates red to indicate that charging
has commenced.
4. A discharged battery pack will take
approximately 2 hours, 30mins to fully charge.
When charge is complete the LED will
illuminate green.
NOTE: If the LED on your CSBHX flashes red
this indicates that there is a fault with the battery
pack. Please consult your dealer.
CSBHX (EE/ED)
6 WAY RAPID CHARGER
v03/09
Note: the CSBHX is the direct replacement /
upgrade of the CSB400E, and is compatible
with the same products.