User manual

FEATURES
OPERATING INSTRUCTIONS
Thank you for purchasing the CSAHX rapid
charger. This product should reach you in perfect
condition. Should you notice any defects or
experience any problems with this product, please
contact the dealer from whom you purchased it
immediately.
The CSAHX charger provides rapid recharging
of Lithium-Ion battery packs for the Entel HX400
series transceivers.
Free-range power supply facilitates both 100v
and 240v AC outlets.
The HX400 series battery pack can be charged in
the front slot of the dual-slot CSAHX charger
while still attached to your HX400 transceiver, or,
alternatively, on its own in the rear slot. Two
battery packs may be inserted into the front and
rear slots simultaneously, but the battery pack in
the rear slot will only begin charging once the
battery pack in the front slot has completed its
charge cycle.
The time required to charge a fully discharged
battery pack is 2 hours, 30mins.
When rapid charge is complete, the CSAHX
automatically switches to standby.
This charger has been designed to sit on a
desktop.
1. Plug the AC power cord of the charger into a
wall outlet.
2. Switch the transceiver off.
3. Insert the battery pack into the CSAHX, either
with or without the transceiver attached.
The LED illuminates red to indicate that charging
has commenced.
4. A discharged battery pack will take
approximately 2 hours, 30mins to fully charge.
When charge is complete the LED will
illuminate green.
NOTE: If the LED on your CSAHX flashes red
this indicates that there is a fault with the battery
pack. Please consult your dealer.
CSAHX (EE/ED)
INTELLIGENT RAPID CHARGER
Copyright Entel UK 2009
v03/09