Installation Instructions

Page 5 Page 6
Page 1
Two-wire Fixture Mount Sensor
(SU-5F-2W)
Installation Instructions
Shipped Components
• Enlighted Two-wire Fixture Mount Sensor
Supplemental Components
• 18 AWG solid copper wire, rated >= 300V
Tools you may Need
• Wire stripper
93-02938-01 Rev01
Model: SU-5F-2W
FCC ID: AQQ-SU5F
IC: 10138A-SU5F
FCC and Industry Canada Compliance Information
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules and Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions:
• this devi
ce may not cause harmful interference, AND
• this de
vice must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by Enlighted Inc.
could void the user's authority to operate the equipment.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes:
• l'appare
il ne doit pas produire de brouillage, ET
• l'utilisateur de l
'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
CE
This device complies with the essential requirements and other relevant
requirements of the R&TTE Directive (1999/5/EC). The equipment is Class 1
radio equipment which can be placed on the market and be put into
service without restrictions in accordance with article 1(3) of Commission
Decision 2000/299/EC (Version July 2014).
Technical Support
For questions regarding the installation or operation of this
product, contact Enlighted
Technical Support: [e-mail]
Company Contact Information
Location: 930 Benecia Ave, Sunnyvale, CA 94085
Phone: [phone]
Web: enlightedinc.com
Copyright © 2019 Enlighted Inc. All rights reserved.
All o
ther brand or product names are trademarks of their
respective companies or organizations.
LED Status Description/Solution
LED not on Check power and wiring
Purple solid All LEDs are on during boot time for 5-6
seconds
Green blinking Sensor commissioned and working
Red blinking Sensor is not commissioned and has
detected a wiring issue. Check wiring to the
LED driver.
Red solid Faulty sensor – replace sensor
Green solid Sensor installed, initialized, and not
commissioned – waiting for discovery
Blue solid Sensor received a request to identify itself
LED Description