User's Manual

Page 5 Page 6
93-02056-01 Rev02 Page 1
Technical Support
For questions regarding the installation or operation of this
product, contact Enlighted
Technical Support: [e-mail]
Company Contact Information
Location: 930 Benecia Ave, Sunnyvale, CA 94085
Phone: [phone]
Web: enlightedinc.com
FCC and Industry Canada Compliance Information
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules and Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions:
• this device may not cause harmful interference, AND
• this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by Enlighted Inc. could
void the user's authority to operate the equipment.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
• l'appareil ne doit pas produire de brouillage, ET
• l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
CE
This device complies with the essential requirements and other relevant
requirements of the R&TTE Directive (1999/5/EC). The equipment is Class 1 radio
equipment which can be placed on the market and be put into service
without restrictions in accordance with article 1(3) of Commission Decision
2000/299/EC (Version July 2014).
Copyright © 2017 Enlighted Inc. All rights reserved.
All other brand or product names are trademarks of
their respective companies or organizations.
Micro Sensor
(SU-5E)
Installation Instructions
Model No. : SU-5E-01
FCC ID: AQQ-SU5E
IC: 10138A-SU5E
Micro Sensor and Carrier
Shipped Components
• Enlighted Micro Sensor
Supplemental Components
• Enlighted Sensor Cable
• Enlighted Control Unit
Tools you may Need
• 7/8” Drill bit (1/2” knock out trade size)
• Hand drill
LED Status Description/Solution
LED not on Check power and wiring
Green
blinking
Sensor commissioned and working
Red blinking Sensor not commissioned
Red solid Faulty sensor – replace sensor
Green solid
Sensor installed, initialized, and uncommissioned –
waiting for discovery.
Blue solid Sensor received a request to identify itself
LED Description
Step 1: Connect the RJ12 end of the sensor cable to the
Control Unit (CU). For wiring connections from the Control
Unit to the sensor, refer to the Control Unit Installation
Guide.
Connecting the Sensor Cable to the Control
Unit
Step 2: Energize the luminaire and confirm that the green
LED is solid.
R
005-101515