User's Manual

Enlighted Compact Sensor Installation Instructions September, 2013
Enlighted Compact
Sensor Installation
Instructions
Shipped Components
The following components are shipped with the Enlighted Compact Sensor Unit:
• Enlighted Compact Sensor Unit
•Compact Nut
Tools You May Need
• Whole Saw
• 11/16 Drill Bit
Installing the Enlighted Compact Sensor
This section provides step-by-step instructions on how to install the
Enlighted Compact Sensor.
Before You Begin
Before you begin the installation of the Enlighted Compact Sensor,
be sure to review the following cautionary steps to ensure a safe
installation:
1. Disconnect all power before installation or service.
2. Installation and maintenance must be performed by qualified
personnel.
3. Installations and maintenance must be performed in accordance
with state, local, and national electrical codes and requirements.
To Install the Enlighted Compact Sensor
To install the Enlighted Compact Sensor Unit, perform the following
steps:
Figure 1: Fixture Combo
Figure 2: Wiring Diagram
Troubleshooting the Enlighted Compact Sensor
Step Action
1. Turn off all power to the light fixture by switching off the circuit breaker.
2.
Ensure the RJ12 data cable is installed and connected to the Enlighted
Control Unit mounted in the ballast cavity of the fixture or mounted in a UL-
approved enclosure. (See Figure 1)
3.
Ensure the Enlighted Compact Sensor is mounted within a few feet of the
lighting fixture and over the service area of light or on adjacent tile.
4.
Select a location for the RJ12 data cable to exit the plenum and make a
small circular cut (roughly 11/16th) in the tile or fixture for the sensor at
specified distance.
5. Insert Enlighted Compact Sensor into hole.
6.
Use Compact Sensor Nut to fasten Compact Sensor (optional –
depending on installation type).
7.
Connect linear 6pin connector to the Enlighted Compact Sensor. (See
Figure 2)
8. Replace ceiling tile.
Problem Solution
There are no green flashing LED lights.
Verify Enlighted Compact Sensor cable
is plugged into the Enlighted Compact
Sensor.
Red blinking LED.
Possible solutions:
• replace Enlighted Compact Sensor
cable
• replace Enlighted Control Unit