EMB01-12R Firing System Instruction Manual Thank you for purchasing this EMB01-12R Wireless Fireworks Firing System. Please read these instructions carefully for a thorough understanding of how the firing system operates.
1. CAUTIONS This product is only used for igniting fireworks. The user must use this product according to the local laws and regulations. Please keep the power off when you are connecting the fireworks. Please keep away from the fireworks when you are igniting them. It is low voltage alarm while the Power LED blinks, please replace the battery. 2. Product Feature 12 cue Modes: Single Fire, Salvo Fire Frequency: OOK, 433MHz Transmitting Range:1000 Meters.
4. Instructions Learn code of the transmitter: Turn the Function Switch to “Single”, “Seq.0+” or “Seq.1+”. Keep pressing the Learn Button until the Status LED lights, press the button of the remote controller within 3 seconds, the Status LED blinks. Turn the Group Switch to choose which group the receiver belongs to. The Firing System EMB01 can be divided into 4 groups, there are 12 receivers in each group. So it can be 48 sequence numbers while sequential fire and step fire.
6. Federal Communications Commission Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.