EMB01-04R Firing System Instruction Manual Thank you for purchasing this EMB01-04R Wireless Fireworks Firing System. Please read these instructions carefully for a thorough understanding of how the firing system operates.
1. CAUTIONS This product is only used for igniting fireworks. The user must use this product according to the local laws and regulations. Please keep the power off when you are connecting the fireworks. Please keep away from the fireworks when you are igniting them. It is low voltage alarm while the Power LED blinks, please replace the battery. 2. Product Feature 4 cue Remote controller FCC ID certified, Receiver module FCC & CE certified.
4. Instructions Learn code of the remote controller: Turn the Function Switch of the receiver to “Single”, “Seq.0+” or “Seq.1+”. Keep pressing the Learn Button until the Status LED lights, press the button of the remote controller within 3 seconds, the Status LED blinks. Turn the Group Switch to “G1”. The sequence number of the receiver is according to the learned number of the remote controller. Keep the power off, and connect the fireworks. Turn the Function Switch to “Test”.
6. Federal Communications Commission Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.