IntegrAlarm USER AND INSTALLER MANUAL (DOOR / WINDOW CONTACT SENSOR) IntegrAlarm MODEL IA-DWC1 February 09, 2004 Document # E.0015.16.
Table of Contents 1 IntegrAlarm Overview..........................................................................3 2 Door / Window Sensor ........................................................................5 2.1 Description ............................................................................................5 2.2 Technical Specifications ......................................................................5 2.3 Installation ..............................................................
1 IntegrAlarm Overview The IntegrAlarm wireless security system includes a Control Panel and a number of wireless peripheral units. The system operates on the ISM wireless band of 902-928 MHz, in frequency hopping mode, transmitting short (about 10 ms) packets of data, with each packet transmitted on a different frequency. Time and frequency synchronization is maintained by a synchronization signal transmitted by the system Control Panel to the various peripherals (including the IA DWC-1) every 3 minutes.
FCC Compliance Statement The FCC Wants You to Know This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
2 Door / Window Sensor 2.1 Description The door / window sensor unit consists of an RF transceiver, a micro-controller, a nonvolatile memory, a power supply, a magnetic switch, a tamper switch and a battery. The sensor unit is composed of the following principal parts: • Sensor assembly. • Magnet block. • 3V Lithium HNO2 battery type CR2. The sensor assembly includes the following subassemblies: • Mounting plate. • Sensor base. • Sensor PCB with RF controller, terminal block, reed switch and LED. • Cover.
2.3 Installation Installation of each door / window sensor is a three-step procedure. The sensor should first be registered via the IntegrAlarm Control Panel. It should then be mounted on the door or window to be secured, and then tested to confirm that it operates properly. 2.3.1 Registration From Installer Menu on Control Panel, select ENROLL. Screen will show: ENTER ZONE # Use numeric keypad at right of Control Panel to enter the desired zone number. The description of the zone number (e.g.
Note: Ensure that the part of the door / window frame intended for the installation is flush with the door / window itself, so that the magnet is opposite the row of raised dots on the sensor assembly outer cover. This positioning ensures that the magnet will activate the sensor when the door / window is opened or closed. If the door / window frame protrudes outward beyond the door / window, it may be necessary to remove part of the protrusion in order to accommodate the door / window sensor.
Document # E.0015.16.
Document # E.0015.16.