Emtech RC10L-5 Remote Control for DSP/Automixers Pin-out for the 8-Pin female DIN connector on the stainless steel wall plate, as viewed from the rear of the connector.
Setting Up the RC10L-5 Remote Control There is a SP3T switch located on the backside of the PCB inside the enclosure of the RC10L-5. Access the switch by removing the back piece of the enclosure. The RC10L-5 is shipped with the switch in the off position, which leaves Pin 5 on the DIN connector in an open state. If your DSP or Automixer needs to sense a ground on Pin 5, then move the actuator on the switch to GND.