FCC INFORMATION The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph: This equipment has been tested and found to comply with the limits for a Class B digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Notice The information in this document is subject to change in order to improve reliability, design, or function without prior notice and does not represent a commitment on the part of EMACS. No part of this document may be reproduced or transmitted in any form or by any means without the prior written permission of EMACS. Trademark Acknowledgments PRISM 2 is registered trademark of Interstate, Inc. Microsoft Windows are registered trademarks of Microsoft Corp.
Software Installation Guide Run the program “Sextuplet” in driver disk, in Win95/98. Then follow the instructions shown on the windows, you can setup the adapter to work correctly. Notice: If you have an Access Point and want to setup your adapter in infrastructure mode, you just must know your SAID of your wireless LAN prior. Otherwise, must have the SAID and channel number in ad-ho mod, the same with who you want to communicate.
Hardware Installation Guide Ste pl ~Turn on the Notebook/Desktop PC, and boot-up with Win95/98. Step? — Insert the EMACS A2424 11Mbps ELAN PC Card into one of the Notebook/Desktop PC build-in PCMCIA slots. Step ~The windowsill will show the message as below to indicate that there is a new device found. EMACS AZ4241 EEE 8027711 Thighs ELAN PC Card Bg Windows is installing the ime for your hies hardware. You don’t have to do anything in the rest of time. But sometimes, it will need some window system files.
Ste pd —~Wait a moment, windowsill will show that it has finished the installation of EMACS A2424 11Mbps ELAN PC Card. Step S —Next, go to the “control panel” -> “system” -> “device manage”, you will see something like below.
In general, you want to see your network neighbors , it’s better has both of TCP/IP and Netball network components included in you window's network configuration. In “Control you should look both, just like below. CIRCLET IP ENACT AREA JEER 802.
Setting up your LAN card If you had installed your wireless LAN card, and you want to change your network setting. You can do as follow... Ste pl —In your Win95/98, go to “control which will show as following. [BC son Micros HEE 8) Microsoft Family Logan Double chicks pantheon fom of “EMACS A2474 [EEES02.11 11Mbps ELAN PC Card” to set up your adapter.
Step ~Click on the item of “Network Type” in the “Property” filed, to determine your network type is either “infrastructure” or “Ad Hock, which will show in the field of “Value”, Fragmentation Threshold Infrastructure STA Lister nits
Step —Click on the item of “SAID” in the “Property” filed, to determine your network name( or so called Service Set ID} in the field of “Value”. Fragmentation Threshold IEEE 602.11 LAN infrastructure STA Listen Intel; ; Network Type F y Power Save Mode RTS Threshold il Dynamite Rte Usa Wap Note: When setting the SAID, you must make sure your network type is either Infrastructure or Ad-Ho. 1. In Infrastructure mode, the SAID mus be the same with the SAID of your Access Point. 2.
Step S —Click on the item of “Channel” in the “Property” filed, to determine you ad-ho mode’s channel. This is only useful in ad-ho mode. Don’t try to setup channel in infrastructure mode. It’s determined by your Access Point. EMACS A24241 [EEE 802.11 11Mbps ELAN PC Card Pope.