GET-125 installation manual A. The installation flow chart is as follows: 1、Attach shielding materia 2、Split control card 3、Installation control card 4、The performance test 5、Clean the PCB 6、Double-sided tape on the back of control card 7 、 Double-sided adhesive is affixed to the back of antenna 8、Fixed control panel 9、Paste insulating film 10、Appearance test B. The detailed installation process is as follows: 1、 Attach shielding materia: 1.1.
before use; 1.2. Joint before must ensure the neatness of PCB, shielding materials, PCB, shielding materials and platform must be perfectly, can't offset, shielding material can't fold, not beyond the PCB edge, the intracrystalline shrinkage is less than 1.0 mm. Figure 1 and 2: Figure 1 2、 Figure 2 Split control card: The control card is placed in the fixed slot, press the work button, and separate the control card.
Push the line to the bottom of the connector and press down the connector cover, 4、 The performance test: Test the electromagnetic panel to be tested by connecting the test equipment to the test equipment: Observe whether there are bending, line breaking, cursor not in position, shake and other fault defects.
On the back of the control card, paste 30*20*T0.
9 、 Paste insulating film: Attach the yellow insulating film to the front of the control card to avoid the connector on the control 10、 Appearance test: Inspect the appearance of the finished product, screen and label the defective products with defects such as the edge of PCB, the edge of the board and the dirty surface of the board. C. inspection and packing Send the good products to the inspection, after inspection qualified, packaging into the warehouse.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.
such function is available. The final end product must be labeled in a visible area with the following: “Contains IC: 10301A-GET125K”. Plaque signalétique du produit final L'appareil peut être conservé aussi loin que possible du corps de l'utilisateur ou que le dispositif est réglé sur la puissance de sortie la plus faible si une telle fonction est disponible. Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC: 10301A-GET125K ".