USB 2.
CLASS 1 LASER PRODUCT APPAREIL A LASER DE CLASSE 1 LASER KLASSE 1 LUOKAN 1 LASERLAITE PRODUIT LASER CATEGORIE 1 CAUTION CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID DIRECT EXPOSURE TO BEAM. VORSICHT KLASSE 3B SICHTBARE UND UNSICHTBARE LASERSTRAHLUNG WENN GEOFFNET. NICHT IN DEN STRAHL SEHEN. ATTENTION RADIATION DU FAISCEAU LASER VISIBLES ET INVISIBLES DE CLASSE 3B EN CAS D'OUVERTURE. EVITER TOUTE EXPOSITION AUX RAYONS.
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Table of Contents INTRODUCTION ABOUT USB SYSTEM REQUIREMENTS PACKAGE CONTENTS INSTALLATION HARDWARE INSTALLATION DRIVER INSTALLATION SOFTWARE PACKAGE DVD REGIONAL CODE OPERATION & CONNECTION FRONT PANEL REAR VIEW TECHNICAL DATA 1 2 3 3 4 4 5 5 6 8 8 10 11
INTRODUCTION Accompanying the new DVD storage technology, we are honored to present you a compact and multiformat external drive with USB 2.0 interface: DVD Writer supporting DVD±R/RW and DVD-RAM writing. This USB 2.0 DVD Writer frees up precious bay space and offers more backup choices other than acting as a CD-R/RW drive and as a DVD-ROM reader.
16X DVD±R , 8X DVD+R Double Layer , and 4X DVD-R Dual Layer writing; 5X DVD-RAM , 8X DVD+RW, and 6X DVD-RW rewriting speed; and 16X DVD-ROM reading speed 48X CD-R writing, 24X CD-RW rewriting, and 48X CD-ROM reading speed Adopts “MTKSuperLink” technology to prevent buffer underrun errors of CD & DVD writing Supports writing modes of TAO, DAO, SAO and packet writing Supports MultiRead function Serves as RPC-2 DVD-ROM Drive Smooth DVD playback Compatible with most existing DVD-ROM drives and DVD video players
*1 You can connect and disconnect devices while the computer is running. *2 USB 1.1 can transfer data at rate up to 12Mbps. System Requirements For IBM compatible PCs, the system requirements recommended are as follows: Pentium III, 800MHz or above with at least 256MB of memory Minimum 2GB free Hard Disk space Operating system: Microsoft Windows 98SE/ME/2000/XP USB 2.0 PCI host card (If there’s no USB 2.0 built-in port in the PC system.) Package Contents USB 2.0 DVD Writer Power adapter with power cord.
INSTALLATION Hardware Installation 1. Connect the power adapter with the AC power cord to the drive. 2. Attach the USB 2.0 cable to the drive. USB Connector 3. Attach the other end of the USB 2.0 cable to the USB port in your computer. The drive is now ready to use. ♦ If you are installing a USB 2.0 drive, your computer must have a USB 2.0 port to achieve the highest speed. You may experience slower drive performance if connected to USB 1.1.
Note: ♦ Be sure to use the USB 2.0 cable bundled with the drive. ♦ Never plug or unplug in any other USB device while the drive is transferring data. It’s likely to lose data. ♦ It’s advisable not to disconnect the drive or unplug the power to the drive while a CD is inserted. ♦ Do not connect more than two rewritable optical drives to USB port of the computer.
innovative way. No matter you are a novice or an experienced user; this is your best recording tools with the writer. Installation Under Windows Environment 1. Insert the application CD and the installation program will run automatically. Then follow the on-screen procedures. Or 2. Run:\setup.exe on the application CD.
Region 2: Japan, Europe, South Africa, and Middle East (including Egypt) Region 3: Southeast Asia and East Asia (including Hong Kong) Region 4: Australia, New Zealand, Pacific Islands, Central America, Mexico, South America, and the Caribbean Region 5: Eastern Europe, Indian subcontinent, Africa, North Korea, and Mongolia Region 6: China About This Drive This DVD Writer is also a RPC2 DVD-ROM drive and according to DVD-Forum, PC chip must be designed into DVD-ROM drives to record how many times a user has
OPERATION & CONNECTION Front Panel 4 5 10 1 6 7 2 3 8 9 11 1. A-Type USB Extension Port This USB port is Plug-and-Play Ready. Just plug your USB device and the computer will detect automatically. 2. Close/Eject Button This button opens and closes the disc tray. If the tray is closed, pressing the button will eject it. 3. Led Indicator (DVD-Dual Drive) While the tray goes in/out, the LED flashes green and it’s off when the drive is ready.
5. Emergency Eject Hole When the Close/Eject button doesn’t work properly and the disc tray can’t be opened, you can insert a paper clip or a small rod into this hole for manual ejection. Please make sure to power off the system before you do that. 6. Slot for Memory Stick (MS)/MS Duo/MS Pro/MS Pro Duo 7. Slot for Secure Digital (SD)/Mini SD/MultiMediaCard (MMC) /Mini MMC 8. Slot for Compact Flash (CF) Type I, II/MicroDrive 9. Slot for Smart Media (SM) 10.
Rear View 1. USB Connector 2. D.C.
TECHNICAL DATA Interface USB 2.0 Disc Capacity DVD+/-R, DVD+/-RW: Single layer 4.7GB Double layer 8.5GB DVD-RAM: 4.
Reading Speed DVD+/- R: DVD-RAM: DVD+/-RW: max. 12X, max. 5X max. 8X DVD+R/-R DL: max. 8X CD-R: max. 48X CD-RW: max. 32X CD-ROM: max. 48X DVD-ROM: max.
Weight Dimension Drive without holder Drive with holder (Optional) holder (optional accessory 188g (per unit) drive (only) 1160g Height 51.5 mm Width 160.0 mm Depth 193.0 mm Height 77.5 mm Width 193.5 mm Depth 193.0 mm Mounting Method RMS output Voltage Horizontal Line out = 0.6 ± 10%Vrms Power Requirement input: AC 100~240V, 50/60Hz output: 5V 2.5A, 12V 1.
3100553241 Version 1.1 Mar.
