ECA4 and ECA44 Manual.indd, Cover 1 of 1 - Pages (12, 1) 8/4/08 LOUDSPEAKERS ECA4 ECA44 Model Model 382 Marshall Way, Layton, Utah • USA • 84041 Phone: (801) 991-1308 • Fax: (801) 543-3300 www.emptek.com It is EMP Tek policy to continuously incorporate improvements into products; all specifications are subject to change without notice. Copyright © 2008 EMP Tek. All Rights Reserved.
Introduction Congratulations on your purchase of an EMP Tek ECA4 or ECA44 compact theater speaker! Your speaker is the result of many years of research and development dedicated to producing powerful, high-quality home audio systems. This manual contains setup recommendations and specifications for the ECA4 and ECA44 compact theater speakers. It is recommended you thoroughly read through the material contained in this manual before connecting your speakers.
Features At the heart of the ECA4 and ECA44 compact theater loudspeakers are proprietary aluminum cone woofers and midrange drivers. The special material combines stiffness, low mass and self-damping properties in a manner that allows virtually uncolored presentation of program material. A powerful magnet, extended voice coil and bumped back plate give the bass/ midrange drivers high excursion capability. This ensures accurate dynamic reproduction.
System Setup To extract the best possible sound from your speaker system, it is important to determine where the speakers will sound best in your listening room. Room reflections from the floor, ceiling and side walls influence the balance, imaging and overall sonic quality at the listening position. Experiment with speaker placement to determine which location offers the best overall sound. As a general guide, use the room layout diagram and the following descriptions when setting up a home theater system.
System Setup (continued) Front Main Speakers As a suggested starting point for the front left and right main speakers, try to place your speakers about 15 inches from the wall and 7 feet apart from each other. The distance from the listening position to each speaker should be close to the distance that separates the two main speakers (i.e. triangle). The EMP compact theater speakers can also be hung on a wall or placed in bookshelves to better match your décor.
Attaching Speaker Wires When using a banana plug to attach speaker wires to the binding post terminals, remove the black and red plastic protective inserts from the terminals. To do this, loosen the binding nut from the terminal by turning the nut counter-clockwise until the nut is completely removed from the terminal. Remove the plastic inserts by pulling them straight out, then replace the nut to the terminal and turn clockwise.
Specifications Model ECA44 ECA4 Frequency Response: 100Hz – 20Hz ±3dB 100Hz – 20Hz ±3dB Sensitivity: 88dB (2.83V@1m) 85dB (2.
Warranty Engineered Music Products “EMP Tek” warrants the ECA44 and ECA4 speakers (the "Product") to be free from original manufacturing defects in materials and workmanship for five (5) years from date of purchase from an authorized EMP Tek dealer. This warranty extends only to the original consumer purchaser. EMP Tek does not warrant goods used in industrial applications. This warranty does not cover any expenses incurred in any removal or re-installation of the product.
ECA4 and ECA44 Manual.indd, Cover 1 of 1 - Pages (12, 1) 8/4/08 LOUDSPEAKERS ECA4 ECA44 Model Model 382 Marshall Way, Layton, Utah • USA • 84041 Phone: (801) 991-1308 • Fax: (801) 543-3300 www.emptek.com It is EMP Tek policy to continuously incorporate improvements into products; all specifications are subject to change without notice. Copyright © 2008 EMP Tek. All Rights Reserved.