EM6555 - e-Domotica Lamp Holder
| ENGLISH EM6555 - e-Domotica Lamp Holder Warnings and points of attention Due to laws, directives and regulations set out by the European Parliament, this device could be subject to limitations concerning its use in certain European member states. In certain European member states the use of this product could be prohibited. More information regarding this warning can be found in the Declaration of Conformity on the last page of this document! Table of contents 1.0 Introduction.........................
| ENGLISH 1.2 Packing contents The following parts need to be present in the packing: • • EM6555 lamp holder User manual 2.0 Using the lamp holder A few short and simple steps are necessary to connect and assign the lamp holder to the EM6500 e-Centre. There are two situations possible: • Assigning the lamp holder to a new e-Centre (see chapter 2.1) • Assigning the lamp holder to an existing e-Centre (see chapter 2.2) 2.1 Assign the lamp holder to a new Eminent e-Centre 1. 2. 3. 4.
| ENGLISH 11. Give the device a name and give a location to the lamp holder. 2.3 Removing the lamp holder from the e-Centre 1. 2. 3. 4. 5. 6. 7. 8. 9. Make sure your computer is completely started. Make sure the E27 socket is switched on. Open your computer’s web browser. Type in your web browser’s address bar: ‘http://e-Centre’ and press ‘Enter’. The Eminent e-Centre’s openings screen will be shown. Click ‘e-Domotica products’. Click the ‘Remove’ button. Press the button on the lamp holder.
| ENGLISH product and/or products of which, without reasonable doubt, can be assumed that wear and tear show a different pattern than the main product are not covered by the Eminent warranty. Products are not covered by the Eminent warranty when subjected to incorrect/improper use, external influences and/or when opened by parties other than Eminent. 6.
EM6555 | 09-2009
